Bosch WAE 24163 Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Bosch WAE 24163. Bosch WAE 24163 8 páginas.
Imprimir páginaWhat to do if ...
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
– Start/Pause not selected?
– Tap not turned on?
Detergent not dispensed.
– Filter blocked? Clean the filter –> page 10.
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
– Is Spülstop (Rinse Hold, without final spin) selected? –> page 3, 4.
cannot be opened.
Programme does not
– Start/Pause selected?
start.
– Washing machine door closed?
Detergent solution is not
– Is Spülstop (Rinse Hold, without final spin) selected? –> page 3, 4.
drained.
– Clean the detergent solution pump –> page 10.
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Unsatisfactory spin
– Not a fault - the unbalanced-load detection system has cancelled
result.
the spin cycle because of uneven distribution of the laundry.
Laundry wet/too damp.
Distribute small and large items of laundry evenly inside the
drum.
–
Reduced Ironing selected? –> page 5.
– Too low a speed selected? –> page 5.
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
imbalance.
several times.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary –> page 9.
products.
Odour formation in the
– Run programme
standard detergent.
washing machine.
Foam escaping from the
– Too much detergent used?
detergent drawer.
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and "walking"
Secure the appliance feet –> Installation instructions.
during the spin cycle.
– Transportation safety devices removed?
Remove the transportation safety devices –> Installation
instructions.
The indicator lights do
– Power cut?
not function during
– Fuses tripped? Reset/change the fuse.
– If the fault occurs repeatedly, call the after-sales service.
operation.
Programme sequence
– Not a fault - unbalanced load detection system adjusts
imbalance by repeatedly distributing the laundry.
longer than usual.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on
– Occasionally, phosphate-free detergents contain water-insoluble
residues.
the laundry.
– Select
If you cannot correct a fault yourself or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service –> Installation instructions.
Cottons 90 °C without laundry. Use
Rinse/Spin
or brush out the laundry after washing.
Washing machine
en Instruction manual
11