Bosch WAJ Series Manual de instrucciones e instrucciones de instalación - Página 37
Navegue en línea o descargue pdf Manual de instrucciones e instrucciones de instalación para Lavadora Bosch WAJ Series. Bosch WAJ Series 40 páginas.
Imprimir página
Display
: of the 'Ready in'
time flashes
. of the 'Ready in' time
lights up
Other displays
*depending on the model
Faults and what to do about them
Faults
Water is leaking from the
machine.
The machine is not filling
with water.
Detergent is not being dis-
pensed.
The door cannot be
opened.
The program will not
start.
The drum briefly jerks or
judders after the program
has started.
The water is not draining.
Water is not visible in the
drum.
* depending on the model
Cause/Remedy
Mains voltage is too low. The program will continue after the voltage supply is recov-
ered.
Undervoltage in the wash programme. The programme is extended. ~ Page 31
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services. ~ Page 39
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw connection of the drain hose.
■
Have you pressed the A button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter. ~ Page 34
■
Note:
If an additional water filter has been installed (depending on model),
check for contaminants and clean if required ~ separate installation and
cleaning instruction for water filter.
Is the supply hose kinked or trapped?
■
The safety function is activated.
■
For safety reasons, the washing machine door remains locked when
Note:
the water level or temperature is high (See ~ Cancel the programme
~ Page 30) or while the drum is rotating.
Is the E childproof lock activated? Deactivate it. ~ "Childlock"
■
on page 29
Is - - - - selected (Rinse Stop = no final spin, water level is high)?
■
~ Page 30
Can the door only be opened by the emergency release? ~ Page 35
■
Have you pressed the A or Finished in-time button?
■
Is the door closed?
■
Is the E childproof lock activated? Deactivate it. ~ "(E 3 sec.)"
■
on page 29
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash program starts.
Is - - - - selected (Rinse Stop = no final spin)? ~ Page 30
■
Clean the drain pump. ~ Page 33
■
Clean the drain pipe and/or the drain hose. ~ Page 34
■
Not a fault – the water is below the visible area.
Faults and what to do about them
en
37