Draper 19392 Manual - Página 8
Navegue en línea o descargue pdf Manual para Herramienta eléctrica Draper 19392. Draper 19392 20 páginas. 12v oscillating multi-tool
Imprimir página
5. Health and Safety Information
Power tool use and care
• Do not force the power tool. Use the correct power
tool for your application.
− The correct power tool will do the job better and
safer at the rate for which it was designed.
• Do not use the power tool if the switch does not turn it
on and off.
− Any power tool that cannot be controlled with the
switch is dangerous and must be repaired.
• Disconnect the plug from the power source and/or
remove the battery pack, if detachable, from the
power tool before making any adjustments, changing
accessories or storing power tools.
− Such preventive safety measures reduce the risk
of starting the power tool accidentally.
• Store idle power tools out of the reach of children and
do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool.
− Power tools are dangerous in the hands of
untrained users.
• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use.
− Many accidents are caused by poorly maintained
power tools.
• Keep cutting tools sharp and clean.
− Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier
to control.
• Use the power tool, accessories and tool bits, etc., in
accordance with these instructions, taking into
account the working conditions and the work to be
performed.
− Use of the power tool for operations different from
those intended could result in a hazardous
situation.
• Keep handles and grasping surfaces dry, clean and
free from oil and grease.
− Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in
unexpected situations.
Service
• Have your power tool serviced by a qualified repair
person using only identical replacement parts.
• This will ensure that the safety of the power tool is
maintained.
5.2 Additional Health and Safety
Warnings for this Multi-Tool
• Keep your hands and face away from the accessory
when the tool is switched on.
− Keep your hands visible at all times during the
operation.
− DO NOT reach underneath the workpiece.
• The accessory may get hot during use; allow it to cool
after use before attempting to remove it from the
multi-tool.
• Ensure that the accessory is securely fastened in
place before use.
• ALWAYS select the tool speed before switching on the
tool.
• Secure the workpiece; DO NOT hold the workpiece by
hand.
• Check for hidden pipes and cabling within and around
the workpiece before use.
• Some of the accessories for this tool are very sharp;
exercise caution when handling the accessories.
• NEVER start the tool if the accessory is already in
contact with the workpiece.
5.3 Safety Information for Mains-Powered
Chargers and Battery Packs
Important: Use ONLY the Draper Tools 12V range
battery pack and charger supplied with this product. DO
NOT charge any other batteries with this charger.
WARNING! DO NOT use or charge the battery if
leakage is evident. If battery fluid comes into contact
with your skin, rinse immediately with water. For
contact with eyes, flush with plenty of water and seek
medical advice.
Chargers
• WARNING! NEVER charge non-rechargeable or
damaged batteries.
• The supplied charger is for indoor use ONLY.
• Before connecting the charger to the power supply,
check that the plug, cable and charger casing are in
good condition and have any damaged parts
immediately replaced by a suitably qualified person.
• ONLY connect the supplied charger to a rated mains
outlet.
− DO NOT plug the charger into site generators,
engine generators or DC power sources.
– 8 –
EN