Draper D16/16 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Draper D16/16. Draper D16/16 20 páginas.

8. Screw the three downfeed handles

the three holes located in the pinion shaft as

shown in Fig 8.

9. Making sure that the chuck

its capacity, place it down on a bench. Clean

any excess grease off the large end of the

spindle

. Insert the taper into the back of

the chuck and with a scrap piece of timber

and a hammer firmly tap them together.

10. Loosen the nut and bolt

slide the chuck guard

. Tighten the nut and bolt and lift the guard

into the upright position.

11. Now clean the other end of the arbor

Fig.11 from grease and offer it up to the

spindle

. Rotate the arbor and chuck until

the flats on the arbor engage into the spindle

. Then firmly tap once using a hammer and

scrap piece of timber. Should it be required,

removal of the arbor from the spindle is

achieved by lowering the spindle, and with the

depth gauge, lock it in the down position. On

the side of the spindle is a hole which exposes

the top of the arbor (if this cannot be seen

fully, rotate the chuck slightly). Now using the

tool provided, tap into the hole forcing the

arbor down and out.

ASSEMBLY

is opened to

Fig.10 and

up onto the collar

into

Fig.8.

Fig.9.

Fig.10.

Fig.11.

- 9 -