Draper 65839 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Sierra Draper 65839. Draper 65839 20 páginas. 10"

Imprimir página

NOTE:

ENSURE THE POWER IS SWITCHED OFF AND

THE MACHINE UNPLUGGED.

BLADE ADJUSTMENT (FIGS. 7, 8 & 9):

HEIGHT:

To move the blade up or down, turn handle ✵✌

clockwise or anticlockwise depending on

requirements. The locking knob ✶✌ does not

require loosening for this procedure (Fig.7).

CAUTION:

The saw blade must be set slightly higher than the

thickness of the work piece being cut.

TILT ACCURACY:

The saw blade can be adjusted to cut between 0º

and 45º. Loosen knob ✶✌ and slide the blade

assembly until the 0º stop. Tighten knob ✶✌.

Using an engineers square on the table and

against the blade, check the blade is in the 0º

position. If a gap can be seen in between the

square and the blade, adjustment is required, set

the blade to the 45º stop and measure the 45º

angle in the same manner using a protractor.

The 0º adjustment is made on bolt ✷✌ and the 45º

adjustment is made on bolt ✸✌ (Fig.8).

Turn the bolts clockwise or anticlockwise to move

the end stop, altering the blade angle slightly.

When both angles are set accurately, adjust the

angle indication pointer ✹✌ by loosening screw

✺✌. Make a test cut after any adjustment.

TILT:

Loosen lock ✻✌ and move the handle assembly

✼✌ along the arc to the desired angle as

indicated by the pointer ✹✌. Retighten locking

knob ✻✌ (Fig.9).

CAUTION:

Ensure the locking knob ✻✌ is fully secured

before any cutting operations take place.

NO-VOLT ON/OFF SWITCH (FIG.10):

This saw is fitted with a no-volt on/off switch. In

the event of a power failure, the machine will have

to be manually restarted once the power supply

has been reinstated.

To switch the saw ON, press ✾✌.

To switch the saw OFF, press ✿✌.

OPERATION & USE

Fig.7.

✷✌

Fig.9.

✹✌

✺✌

✿✌

Fig.10.

- 9 -

✶✌

✵✌

✻✌

✼✌

✾✌

Fig.8.

✸✌