Draper CS14A Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Sierra Draper CS14A. Draper CS14A 12 páginas. 350mm chop saw
También para Draper CS14A: Manual de instrucciones (16 páginas)

Imprimir página

5 ANGLE CUTING GUIDE (Fig.6)

Loosen screw ✳✌ with the hexagon wrench

provided. Adjust fence ✴✌ to the required angle

and then secure with screw ✳✌. The backstop can

be adjusted backwards and forwards to meet your

requirements.

This is only a guide and practice cuts should be

made using a scarp piece of material first.

Before carring out any maintenance or trouble

shooting operation ensure the power is off and

plug is removed.

6. REPLACING THE DISC (Fig 7 & 8)

With the cutting arm in an upright position press

locking spindle button ✵✌

Using the hexagon wrench provided loosen the

disc flange securing bolt ✶✌. Remove the bolt

and the outer flange ✷✌. Swap over the cutting

discs on the abbor shaft.

Refit the outer flange and tighten the locking bolt

with the wrench and spindle locking button.

NOTE: Do not over tighten as this may cause

damage to the cutting disc.

BRUSH INSPECTION AND REPLACEMENT

CAUTION: Before inspecting the brushes

disconnect the machine form the power supply.

BRUSH WEAR AND REPLACING BRUSHES

On new machine check for brush wear after the

first 50 hours of use, then every 10 hours

Replace brushes when they have worn down

to 5mm.

Unscrew brush covers ✔✌ Fig.9) Remove

brushes Fig 10. Check for wear or replace. NOTE:

When replacing brushes always replace both

brushes.

OPERATION & USE

Fig. 6

✪✌

Fig. 8

✶✌

✷✌

Fig. 9

✸✌

Fig. 10

- 8 -

✳✌

✴✌

✵✌

Fig. 7