Draper 20582 Manual - Página 14

Navegue en línea o descargue pdf Manual para Compresor de aire Draper 20582. Draper 20582 20 páginas. Cordless air compressor
También para Draper 20582: Manual de instrucciones original (20 páginas)

Imprimir página
Draper 20582 Manual
9.

OPERATION

9.1 INFLATING TYRES

1.
Loosen the attachment lock approximately 3
rotations anticlockwise. Do not remove lock
completely.
2.
Important: Insert the air hose with threaded
connector into the attachment lock. Press in
firmly while screwing in clockwise until it can go
no further.
3.
Tighten attachment lock clockwise until
hand-tight to create an air tight seal around the
thread.
4.
Press the Power button below the LCD display to
turn on.
Note: After 30 seconds of inactivity, the digital
tyre gauge will turn off automatically to conserve
energy.
5.
To choose desired pressure format (PSI, BAR,
KPA), press the power button continuously until
desired format displays.
6.
Screw the threaded connector onto tyre's valve
stem. When connected, the gauge will show
current tyre pressure.
7.
Press "+" or "-" to set desired pressure level.
Once set, wait a few seconds until current tyre
pressure displays.
Note: Always check and follow the
manufacturer's recommended pressure, usually
located on the inside of the vehicles door.
8.
Ensure trigger lock is in unlock position, press
the trigger.
9.
The compressor will begin to inflate the tyre to
the set pressure level, and shut off automatically
when reached.
10. When done, press the trigger once to turn off, and slide trigger lock to lock position.
11. Remove the thread connector from the tyre quickly, and replace valve stem cap on tyre, if
required.
Note: Tyre pressures should be checked with a tyre pressure gauge to BSEN12645:1999.
Warning: Connector may be hot. Use caution when removing.
Note: To avoid over-inflation of tyres, please check the recommended tyre pressure in the
vehicle's owner's manual.
For bicycle tyres, check markings on tyre.
Warning: The LCD display must turn on before operating air inflater.
Use a separate pressure gauge for more accurate reading.
FIG.8
FIG.9
FIG.10
- 14 -