Draper DA12/250B Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Compresor de aire Draper DA12/250B. Draper DA12/250B 12 páginas. 12v mini air compressor
Imprimir página
SAFETY WARNING
WARNING: Please read the following instructions carefully failure to do so could lead to serious
personal injury.
IMPORTANT: Draper Tools recommends that this compressor should not be modified or used for
any application other than that for which it was designed. If you are unsure of it' s relative
applications do not hesitate to contact us in writing and we will advise you.
GENERAL SAFETY RULES FOR
AIR COMPRESSORS
1. Know your compressor
Before operating the compressor, read
and fully understand the starting,
operating and stopping sections in this
manual. Read all labels affixed to the
compressor. Learn it' s applications and
limitations.
2. Servicing and maintenance
Do not service or maintain this
compressor until you have read and
understood the maintenance section of
this manual.
3. Check damaged parts
Before further use of this compressor,
parts that are damaged should be carefully
checked to ensure that it will operate
correctly and perform its intended
function. Check for alignment of moving
parts, breakage of parts and any other
conditions that may effect its operation. A
guard or other part that is damaged
should be properly repaired or replaced.
4. Disconnect from power supply
Before servicing, maintaining or replacing
damaged parts ALWAYS disconnect the
compressor from the power supply.
5. Avoid dangerous environments
Do not use the compressor in damp or
wet locations or expose it to rain. Keep the
work area well lit. Provide adequate
surrounding work space.
6. Avoid accidental starting
Make sure the power supply is off before
connecting to the power supply.
7. Never leave the compressor running
unattended
Turn the power supply off. Do not leave
the compressor until it comes to a
complete stop.
8. Use Recommended Accessories
Only use the recommended adaptors as
supplied.
9. Overheating
Operation over an extended period of
time will overheat the unit and damage
the compressor. When this occurs stop the
unit immediately and do not restart until
cool, approximately 30 minutes.
10. Keep children away
Ensure the compressor is stored out of
reach of small children.
11. Tyre pressure
The gauge on the compressor is intended
as a guide only. Tyre pressures should be
regularly checked against a tyre pressure
gauge manufactured to BS4613, such as
Draper Stock No.26443.
- 3 -