Draper Techmatic Window Shade Instrucciones de instalación y funcionamiento - Página 3

Navegue en línea o descargue pdf Instrucciones de instalación y funcionamiento para Mobiliario interior Draper Techmatic Window Shade. Draper Techmatic Window Shade 4 páginas.

Imprimir página
Draper Techmatic Window Shade Instrucciones de instalación y funcionamiento
Techmatic Window Shades
Section 1 - Brackets
Caution: Before mounting shades, verify measurements on card provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
1. Mark wall, jamb or ceiling for placement of mounting brackets.
1. Drill small starter hole
(if necessary)
2. Mount brackets using appropriate fasteners for surface
3. Place spring-loaded pin into bracket, depress pin by pushing shade roller toward bracket
4. Slip notches on operator end into other bracket, then press down to lock in place
5. Install optional bracket covers
SMALL UNIVERSAL BRACKETS - CLUTCH INSTALLATION
1
9
/
"
16
(40mm)
1
9
/
"
16
(40mm)
2
/
"
3
8
(60mm)
2
/
"
3
8
(60mm)
15
/
"
16
(24mm)
2 ¼"
15
/
"
16
(31mm)
(24mm)
2 ¼"
(31mm)
/
"
15
16
(24mm)
/
"
15
16
(24mm)
Section 2 - Endcaps
Caution: Before mounting shades, verify measurements on card provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
1. Mark wall, jamb or ceiling for placement of mounting endcaps.
2. Drill small starter hole
3. Snap endcap
4. Mount endcaps using appropriate fasteners for surface
5. Place spring-loaded pin into idler endcap, depress pin by pushing shade roller toward endcap, slip notches
Figure 4
2"
(51mm)
Figure 5
3 ¼"
(83mm)
2 ¼"
3 ¾"
(57mm)
(96mm)
in mounting surface.
(Fig. 1 for bracket
(if
provided).
Figure 1
Idler
Bracket
/
"
11
16
(17mm)
/
"
11
16
(17mm)
2
/
"
3
16
(56mm)
2
/
"
3
16
(56mm)
2 ¾"
(44mm)
2 ¾"
(44mm)
Retainer Clip
(if necessary)
covers(Fig. 4)
into place.
on operator end into other endcap, then press down to lock in place
ENDCAP INSTALLATION
Idler
Endcap
®
dimensions).
(Fig.
2).
(Fig.
3).
Figure 2
Idler End
of Roller
in mounting surface.
(Fig. 5 for endcap
Figure 6
Idler End
of Roller
Retainer Clip
Figure 3
10 lb Clutch
dimensions).
(Fig.
6).
10 lb Clutch
page 3 of 4
Clutch Bracket
Clutch
Endcap