Draw tite CQT24971 Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Accesorios para automóviles Draw tite CQT24971. Draw tite CQT24971 4 páginas. 2012-current toyota prius c

Imprimir página

Always wear SAFETY GLASSES

when installing hitch

Outer Bolt

Do not Remove

Authorized Drawbar Kit:

3593 (Sold Separately)

Drawbar must be used in the

RISE position only.

1. Remove Appearance Panel – Note: Panels may vary based on vehicle year. Using a flat head screwdriver remove (2) plastic appearance panels

from the driver side. (4) push pins per panel (8 push pins total). Then remove the (5) push pins from the center appearance panel. Finally remove

the remaining (2) push pins attaching the fascia tabs. NOTE: Return the center appearance panel and (5) push pins to the vehicle owner. All other

panels and push pins will be reinstalled in step 5.

2. Remove Bumper Bolts– Using a 12mm socket remove the (1) lower bolt and (1) inboard bolt from the bumper (each side) and return (4) bolts to

vehicle owner. NOTE: Leave the outer bolts attached to the vehicle.

3. Hitch installation – Rotate the passenger side of the hitch over the exhaust and raise into position. Then install items

4. Torque Fasteners – Using a 13mm socket Torque all 8mm fasteners to 27 ft-lb (37 N-M)

Proper torque is needed to keep the hitch secure to the vehicle when towing.

5. Reinstall Appearance Panels – Reinstall the (2) driver side appearance panels removed in step one. Then reattach the (2) fascia tabs from step one.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and

exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut

access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.

Regulation V-5 and SAE J684.

Installation Instructions

PART NUMBERS: 24971, 77971, CQT24971

BUMPER

Rear

BULK HEAD

Fastener Kit: 24971F

Qty. (4)

Hex Bolt

M8x1.25x30mm

CL10.9

Qty. (4)

Conical Washer

3/8"

Part# 01292006

Fasteners

typical

Conical Washer

both sides

Teeth side

Against hitch

BUMPER

Outer Bolt

Do not Remove

and

each side.