Drawell SMART-e-500 Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Microscopio Drawell SMART-e-500. Drawell SMART-e-500 16 páginas.
Imprimir página
3. Installation and Carry
Please clean the operation desk before installation, for
example paper, cotton or packing waste, avoiding any
interference in installation.
Put the microscope from the foam and put it on the desk.
Make sure the power switch is off at "○"and the supply
voltage meets the instrument's requirement .
3.1 Installation Process
(1) Integrative head :
Loose G slightly (use attached wrench except knurled
thumb screw ),put ⑧ into ⑦ main body's joint, adjust
position, tight G again.
(2) Put out the dust cover for reservation .
(3) Eyepiece: pull out and plug in eyepiece tube.
(4) Condenser :
Pull out from package ,swift condenser focusing knob
M slightly, lower condenser installing ring to proper
position. Loosing condenser screw, install condenser,
make scale toward front operator position，Then tighten
condenser screw , raising condenser installing ring to the
top.
Electrical Equipment Checking :
Plug power line in power input ⑨, turn on power switch
L, observe brightness of light collector ⑥ , then continue
the next step. Otherwise, please check the process
according to appendix "common malfunction and
troubleshooting".
▲ Please don't touch eyepiece or optical lens during installation, otherwise will effect the
observation.
3.2 Carry
Microscope is a precision instrument,
careful in carry. Shut down power
supply ， pull out power line. Lock the
eyepiece tube and condenser etc, no
slice
left
on
stage.
nosepiece , focusing knob, mechanical
stage and eyepiece tube etc, don't make
the eyepiece off. Avoid stumble into the
chair, violent shocks and collision can
cause damage.
a. Single hand carry way: with one hand
holding the body, the microscope will
be hold by thumb buttoned filed from
inside.
b. Two hands lift way: one hand turn back the microscope slightly by holding body handle F ,the another
hand holding the microscope's fore piece.
Don't
move
2
3
4
Condenser
screw
Condenser
Installing
ring
Condenser
a
-４-
1
common
b