Bosch XQG80-WAP201601W Manual de instrucciones e instrucciones de instalación - Página 34
Navegue en línea o descargue pdf Manual de instrucciones e instrucciones de instalación para Lavadora Bosch XQG80-WAP201601W. Bosch XQG80-WAP201601W 36 páginas.
Imprimir página
Installation and connection
en
Alignment
Loosen lock nut in a clockwise
1.
direction with a wrench.
Check alignment of the washing
2.
machine with a spirit level and, if
required, correct. Adjust the height
by rotating the foot.
All four feet must be firmly on
Note:
the floor.
The washing machine must not
wobble!
Tighten the lock nut against the
3.
housing.
Grip the foot and do not adjust the
height.
Notes
– The lock nuts on all four
appliance feet must be screwed
tightly against the housing!
– Loud noise formation, intense
vibrations and "wandering" may
be due to incorrect alignment!
Electrical connection
Electrical safety
:
Warning
Danger of death from electric shock!
Danger of death if live parts are
touched.
Never pull out the mains plug by
■
tugging the power cord.
Insert/pull out the mains plug with
■
dry hands only.
Never pull out the mains plug during
■
operation.
Connect the washing machine to an
■
alternating current via a correctly
installed earthed socket only.
34
The mains voltage and voltage
■
specifications on the washing
machine (appliance rating plate)
must match.
Connected load as well as required
■
fuse are indicated on the appliance
rating plate.
Ensure that:
the mains plug and socket match,
■
the cable cross-section is adequate,
■
earthing system has been installed
■
correctly.
A damaged power cord may
■
be replaced by an electrician only.
A replacement mains cable can be
obtained from customer service.
Do not use multiple plugs/couplings
■
or extension cables.
If a residual-current-operated circuit
■
breaker is used, use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
The mains plug must be accessible
■
at all times.
Before washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean programme the first time
without washing.
The washing machine must have
Note:
been installed and connected properly.
See chapter
Installing
Check the machine.
1.
Never switch on a damaged
Note:
machine. Inform your customer
service.
Insert mains plug.
2.
Turn the tap on.
3.
Switch on the appliance.
4.
Close the washing machine door.
5.
Do not load any washing.
~ Page 30