Bosch 8 Series Manual del usuario e instrucciones de instalación - Página 29

Imprimir página

Bosch 8 Series Manual del usuario e instrucciones de instalación

22.5 Installation in a tall unit

Observe the installation dimensions and the installation

instructions when installing in a tall unit.

¡ To ventilate the appliance, the intermediate floors

must have a ventilation cut-out.

¡ If the tall unit has another back panel in addition to

the element back panels, this must be removed.

¡ Only fit the appliance up to a height which allows

accessories to be easily removed.

22.6 Installing two appliances on top of

each other

Your appliance can also be installed above or below

another appliance. Observe the installation dimensions

and the installation instructions when installing appli-

ances on top of each other.

¡ To ventilate the appliances, the intermediate floor

must have a ventilation cut-out.

¡ To ensure sufficient ventilation of the two appli-

ances, there must be a ventilation opening of at

least 200 cm² in the base area. To do this, trim the

base panel or fit a ventilation grille.

¡ Ensure that air exchange is guaranteed in accord-

ance with the diagram.

¡ Only fit appliances up to a height that allows ac-

cessories to be easily removed.

22.7 Corner installation

Observe the installation dimensions and the installation

instructions when installing in a corner.

¡ To ensure that the appliance door can be opened,

you must take the minimum dimensions into consid-

eration when installing in a corner. The dimension

is dependent on the thickness of the unit front and

the handle.

22.8 Electrical connection

In order to safely connect the appliance to the elec-

trical system, follow these instructions.

¡ The appliance corresponds to protection class I and

must only be operated with a protective earth con-

nection.

¡ The fuse protection must correspond to the power

rating specified on the appliance's rating plate and

to local regulations.

¡ The appliance must be disconnected from the

power supply whenever installation work is being

carried out.

¡ The appliance must only be connected using the

power cable provided.

¡ The power cable must be plugged in at the rear of

the appliance until you hear a clicking sound. A 3 m

power cable can be obtained from the after-sales

service.

¡ The power cable must only be replaced with a cable

from the original manufacturer. This is available from

after-sales service.

Installation instructions en

⁠