Bosch 800 Series Manual de instalación - Página 7

Imprimir página

Flush installation

Electrical Installation

The model stated on the front cover is rated at 120V AC,

60 Hz and uses a NEMA 5-20 plug to connect to a

dedicated 120 V microwave circuit.

Model

Connection

HMC84252UC

NEMA 5-20

Electrical Requirements:

a three prong grounded outlet

▯

120 V, 60 Hz, AC only

▯

20 Amp electrical supply with a fuse or a circuit

▯

breaker

Install Appliance

Note: The appliance is heavy. It is advisable to install it

with a second person.

NOTICE: Before installing the appliance, be sure to

verify the cabinet dimensions and electrical connections.

Mount to Cabinet

Fully insert the appliance and center it. Do not kink the

electrical cable.

Screw the appliance into place.

Circuit

Requirements

120 V,

20 Amps

60 Hz

Flush installation also requires:

two side cleats to be attached inside the cabinet

▯

frame, recessed from the front

" (8 mm) baseplate underneath the unit body.

▯

This product must be connected to a supply circuit of the

proper voltage and frequency. Wire size must conform to

the requirements of the National Electric Code or the

prevailing local code for this rating. The power supply

cord and plug should be brought to a separate 20-amp

branch circuit single grounded outlet. The outlet box

should be located inside the cabinet above the appliance

(see section Location Requirements). The outlet box and

supply circuit should be installed by a qualified

electrician and conform to the National Electrical Code or

the prevailing local code.

The voltage used must be the same as specified on this

microwave oven. Using a higher voltage is dangerous

and may result in a fire or oven damage. Using a lower

voltage will cause slow cooking. The dealer is not

responsible for any damages resulting from the use of

the oven with any voltage other than specified.