Bosch 800 Series Manual de instrucciones de instalación - Página 4

Imprimir página

Bosch 800 Series Manual de instrucciones de instalación

Avoiding General Hazards

Do not use the dishwasher until it is completely

installed. When opening the door on an uninstalled

dishwasher,

carefully

supporting the rear of the unit. Failure to follow this

warning can cause the dishwasher to tip over and

result in serious injury.

Before installing the "L"-shaped supplied countertop

mounting brackets (select models), decide which

method will be used to secure the dishwasher into

its opening. Once these mounting brackets are

installed on the dishwasher, removing them is

difficult and will damage the mounting brackets and

the dishwasher.

In some conditions, hydrogen gas can form in a hot

water system that has not been used for weeks.

Hydrogen gas is explosive.

Before filling a dishwasher from a system that has

been off for weeks, run the water from a nearby

faucet in a well ventilated area until there is no

sound or evidence of gas.

Temperatures required for soldering and sweating

will damage the dishwasher's base and water inlet

valve. If plumbing lines are to be soldered or

sweated, keep the heat source at least 6 (152.4

mm) away from the dishwasher's base and water

inlet valve.

Removing any cover or pulling the dishwasher from

the cabinet can expose hot water connections,

electrical power and sharp edges or points. Handle

with care.

Avoiding Electrical Shock/Fire Hazards

Do not allow the electrical and water supply lines to

touch. Separate channels are provided under the

dishwasher.

Do not work on an energized circuit. Doing so could

result in serious injury or death. Only qualified

electricians should perform electrical work. Do not

attempt any work on the dishwasher electric supply

circuit until you are certain the circuit is de-

energized.

WARNING

open

the

door

while

Make sure electrical work is properly installed.

There should be no loose electrical connections.

Ensure all electrical connections are properly made.

The customer has the responsibility of ensuring that

the

dishwasher

electrical

compliance with all national and local electrical

codes and ordinances. The dishwasher is designed

for an electrical supply of 120V, 60 Hz, AC,

connected to a dishwasher-dedicated, properly

grounded electrical circuit with a fuse or breaker

rated for 15 amps. Electrical supply conductors

shall be a minimum #14 AWG copper only wire

rated at 75°C (167°F) or higher.

This appliance must be connected to a grounded

metal, permanent wiring system, or an equipment-

grounding conductor must be run with the circuit

conductors and connected to the equipment-

grounding terminal or lead on the appliance. Do not

use extension cords.

Avoiding Electrical Shock/Fire Hazards

Do not perform any work on a charged hot water

line. Serious injury could result. Only qualified

plumber should perform plumbing work. Do not

attempt any work on the dishwasher hot water

supply plumbing until you are certain the hot water

supply is shut off.

Do not over tighten the 90° elbow. Doing so may

damage the water inlet valve and cause a water

leak.

Temperatures required for soldering and sweating

will damage the dishwasher's water inlet valve. If

plumbing lines are to be soldered or sweated, keep

the heat source at least 6 (152.4 mm) away from

the dishwasher's water inlet valve.

Check local plumbing codes for approved plumbing

procedures and accessories. All plumbing should

be done in accordance with national and local

codes.

These instructions depict an installation method for

stainless steel braided hose or PEX hot water

supply lines. If using copper tubing or other material

for water supply, defer to a licensed plumber for

proper installation.

installation