Bosch FAP-OC 500Series Manual de servicio - Página 24

Imprimir página

Bosch FAP-OC 500Series Manual de servicio

58300000202181 ARA EN B



NOTICE

More than 75% of the control modules returned to the factory are fully

functional. Before diagnosing a bad control module, be sure to

disconnect and reconnect each wire/wire harness.

6.10.1 Combination Oven

On the HBL57M52UC combination oven, the microwave must be

removed in order to reach the access panel on the top front of the

HBL57M52UCC wall oven housing.

 CAUTION

When servicing the standard wall oven component of an

HBL57M52UC combination oven, the microwave oven must be

removed in order to reach the access panel on the top front of the

HBL57M52UCC wall oven housing. To safely remove and reinstall

the microwave, two people are required.

Figure 31 120VAC Microwave oven receptacle

This material is intended f or the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copy ing, disclosure, or distribution in any f ormat is prohibited.

Novemb er 2018

To remove the microwave oven...

6.10.2 Replacing the Control Module or Daughter Board

Figure 32 Control module access panel and Service Guide.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 500 Series Built-in Wall Ovens

1. Remove power to the oven.

2. Remove the screws securing the right and left side trim pieces

to the cabinetry.

3. Carefully slide the combination unit completely out of the

cabinet cutout.

4. Disconnect the feeder wires from the terminal block: only

necessary if a work table is not nearby, and the 5' length of

conduit/wire will not be sufficient.

5. Remove the front decorative trim that is secured to the

universal brackets with two screws.

6. Unplug the microwave's 120VAC plug from the receptacle.

7. Remove the six screws which secure the microwave to the

right and left universal brackets.

8. Carefully lift the microwave off the universal brackets, and set

aside.

9. Proceed to step 13.

10. Remove power to the oven.

11. Remove the screws securing the right and left side trim pieces

to the cabinetry.

12. Carefully slide the oven out of the cutout ~16".

13. Locate the Service Guide (wire diagram) attached to the inside

of the access panel.

Page 24 of 41

800 944-2904