AirStage UTY-DCGG Manual de instalación - Página 7
Navegue en línea o descargue pdf Manual de instalación para Mando a distancia AirStage UTY-DCGG. AirStage UTY-DCGG 9 páginas. Central remote controller
También para AirStage UTY-DCGG: Manual de instalación (11 páginas)
Imprimir página(10)
Install the front panel to the rear panel.
CN13
(11)
Install the screw (1 pc) and fi x the panels.
6. 5.
Installation Method - Separate type
CAUTION
Always use the extension cable of service parts (9708798011) to
connect the separate type power supply unit and control unit. If a
cable outside the specifi cations (accessory connection cable or
other remote controller cable) is processed and used, the power
may not turn on or other trouble may occur.
The length of the extension cable (9708798011) is 5m (16 ft.).
Connect the power supply unit and control unit with the length less
than 5m (16 ft.).
A. Power supply unit wiring
(1)
Pass power supply
cable through Hole-A, and connect it to the
power supply terminal of the power supply unit PC board.
(2)
Fix with
cable tie fi rmly.
Cable tie (accessory)
Power supply
cable
Hole-A
POWER SUPPLY
L N
(3)
Open the knockout of hole-B section, and install the one touch
bush.
(4)
Pass the extension cable (
service parts) through Hold-B, and
connect it to the relay connector coming from the power supply
unit.
*
When installing the front
panel to the rear panel,
install it carefully so that the
cable is not pinched or the
parts of the circuit board are
not pushed by things project-
ing from the rear panel. The
circuit board parts may be
damaged.
POWER SUPPLY
L
N
(5)
Fix with
cable tie fi rmly.
Extension cable (service parts)
Cable tie (accessory)
Hole-B
Relay connector
(6)
Install the power supply unit cover, and tighten the screws (4
pcs).
(7)
Fix the holder 1 assembly (2 places) with screws (2 pcs x 2
places).
Power unit cover
B. Controller body wiring
(1)
Pull around the transmission cable as shown in the fi gure, and
connect it to the terminal of the rear panel.
(2)
Pull around the extension cable as shown in the fi gure, and
connect it to the terminal of the rear panel. And fi x with cable tie
fi rmly.
Transmission cable
Extension cable
(service parts)
Hole-B
One touch bush
(accessory)
POWER SUPPLY
L N
Hole-B
Holder
(accessory)
Screw×4
(When fi xing the Holder,
remove the 4 screws in
advance.)
Screw×4
(Accessories)
Transmission cable
Extension cable
+5V
GND
X1
X2
Cable tie
Terminal
(accessory)
connection
En-6