AirStage UTY-LNHG Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Mando a distancia AirStage UTY-LNHG. AirStage UTY-LNHG 10 páginas. Wireless
También para AirStage UTY-LNHG: Manual de instrucciones (10 páginas)

Imprimir página

■

Address setting

Indoor unit address setting

(7) Press the "MODE"

button to access the

address setting mode.

(8) Make sure the function

number is '01'. If the number

is other than '01', press the

" " or the " " buttons to

alter.

(9) Press the "FAN" button

to access the address

data setting mode.

The address data will

ﬂ ash once this button is

pressed.

(10)

Press the " " or the " " buttons to adjust the address data. The

indoor unit address range is between 00 and 63. Each time the "MODE"

button is pressed, it switches between the one's place and the ten's

place.

Range

00 - 63

DOWN

(11)

Press the "START/STOP" button once to send the information. A

beeping sound will be heard if the command is accepted.

* In the following cases the setting signal is not read and a buzzer

sounds.

The indoor unit address No. is set out of range (64 or more) :

Pi Pi Pi Pi Pi

The setting of the rotary switch on the PC board is not "00" :

Pi Pi Pi Pi Pi

Function number:

Set "01".

Address data

Pi Pi

PiPiPi

(12)

Indoor unit will display the indoor unit address data number on "TIMER

" (ORANGE) and "FILTER

Continuously

Flashing times of

address numbers

(the ten's place)

(Example) ADDRESS : 34

OPERATION LAMP

(GREEN)

0.5sec ON / 0.5sec OFF

TIMER LAMP

(ORANGE)

3 times

0.5sec ON / 0.5sec OFF

FILTER LAMP

(RED)

4 times

* ADDRESS 0 setting will not indicate TIMER LAMP and

FILTER LAMP.

Conﬁ rmation of address setting

(13)

Press the "TIMER set (+)" button.

"TIMER set (+)"

CORRECT :

WRONG :

Refrigerant circuit address setting

Note :

The refrigerant circuit address is displayed when the following

operations are performed even while indoor unit address is

displayed on LED display of indoor unit.

(14)

Press the "FAN" button to

select the function number.

(15)

Press the " " or the " " button to

adjust function number 02.

(16)

Press the "FAN" button to

access the address data

setting mode. The address

data will ﬂ ash once this

button is pressed.

" (RED) light.

Flashing times of

address numbers

(the one's place)

1 - 10 sec

PiPi

PiPiPiPiPi

PiPi

(3 sec)

Function number

Set "02"

Address data

En-4