AirStage UTY-RHKY Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Mando a distancia AirStage UTY-RHKY. AirStage UTY-RHKY 20 páginas. Uty-rhk series
También para AirStage UTY-RHKY: Manual de instalación (8 páginas), Manual de instrucciones (2 páginas)
Imprimir página
NOTES
Operation mode display.
(AUTO)
(COOL)
(DRY)
(Select HEAT or COOL automatically.)
•
If the priority mode is set to "Priority on Administrative Indoor
Unit", the operating mode of other indoor units except
Administrative Indoor Unit will be controlled by an
Administrative Indoor Unit.
•
If the operating mode of Administrative Indoor Unit is set to
"AUTO", "AUTO" is displayed in addition to the display of
current operating mode on other wired remote controllers
except Administrative Indoor Unit. In this case, operation of
other indoor units is controlled by the Administrative Indoor
Unit.
Ex. : When operating mode of the Administrative Indoor Unit
is set to "AUTO" while air conditioning setting.
(The indication on other wired remote controllers
except Administrative Indoor Unit).
When Administrative Indoor
Unit is set to "AUTO".
START / STOP
Each press of the "
START/STOP" button alternates
operation and stop.
When operating, operation lamp (green)
FAN SPEED
Press the "
FAN SPEED" button to select the fan speed
while in operation.
Fan speed display
NOTES
(AUTO)
(HIGH)
(Select the fan speed
automatically.)
9378378001-03_OM.indd 2
Instructions related to heating are applicable to "HEATING PUMP MODELS" and "HEAT RECOVERY
MODELS" only.
(FAN)
(HEAT)
will light up.
(MED)
(LOW)
OPERATION
NOTES
(1) When
is displayed, there are functions for which settings cannot be made.
When a button is pushed to change a restricted setting,
(2) When
is displayed, some operation are restricted. In such case, contact the administrator.
(3) During Automatic Defrosting operation and Oil Recovery operation, "
on the remote controller.
(4) • When "
" or "
" is indicated on the temperature display, it means under maintenance.
• When " " is indicated on the temperature display, anti freeze function is activated.
However, this function cannot be operated by the remote controller.
(5) Preset values are displayed when the "
TEMP." button, the "
(6) Mode indication blinks when inoperative setting of indoor unit is made.
(7) Blinking of the fan speed display means the timing for filter
cleaning of the indoor unit.
To erase indication, press the "
more than 2 seconds.
TEMPERATURE
Press the "
the room temperature while in operation.
Temperature setting range
AUTO • • • • • • • • • • • • • 18 to 30°C
HEAT • • • • • • • • • • • • • 10 to 30°C
COOL/DRY • • • • • • • • • 18 to 30°C
The temperature setting should be considered a standard value,
and may differ somewhat from the actual room temperature.
ERROR CODE DISPLAY
If an error occurs, the following display will be shown.
(" " will appear in the set room temperature display.)
If " " is displayed, immediately contact authorized service
personnel. Do not used the operation as shown to the right
if an error has occurred.
Occurrence of an error is indicated by the blinking of operation
lamp.
will flash.
" will be displayed
TEMP." button or "
FAN SPEED" button is pressed while stopping.
FAN SPEED" button for
TEMP." button or "
TEMP." button to set
NOTES
Error code
Faulty unit No.
(0-15, C0)
Ex. Error code display
5/28/2009 2:25:46 PM