Alemlube O30060 Manual de instrucciones - Página 13

Navegue en línea o descargue pdf Manual de instrucciones para Bomba de agua Alemlube O30060. Alemlube O30060 17 páginas. Oil pump

Imprimir página

Trouble Shooting Guide

Relieve the pressure before you check or repair the dispensing valve. Be sure all other valves and controls and the

pump are operating properly.

To reduce the risk of serious injury whenever you are instructed to relieve pressure, always follow the pressure relief

procedure on page 3.

Problem

Slow or no fluid flow

Filter is clogged, or pump pressure

is low, or shut-off valve is not fully

open, or foreign materials jammed

in the metering element.

Oil leaks from swivel

Swivel is loose

O-Ring is worn or damaged

Oil drips from nozzle

Nozzle is damaged or obstructed

Valve leaks

O-Rings or valve seat are worn or

damaged

Leakage from meter

O-Ring damaged

No display

Loosing battery

Battery out of power

Wrong reading

Correction coefficient error

WARNING: Your risk from these exposures varies, depending on how often you do this type of work. To reduce your

exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those

dust masks that are specially designed to filter out microscopic particles.

NSW/ACT

QLD/PNG

TEL: (02) 9939 0711

TEL: (07) 3889 8480

FAX: (02) 9939 0411

FAX: (07) 3889 8490

OWNER'S TECHNICAL MANUAL

Oil Transfer Kit with Meter & Trolley

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

Solution

1. Relief the pressure.

2. Loose swivel fitting, clean or replace the filter.

3. If the problem remains, contact your distributor for repair

or replacement.

Torque the swivel. If the problem remains, contact your distributor

for repair or replacement

Replace the O-Ring. If the problem remains, contact your distributor

for repair or replacement

Inspect the nozzle for damage or obstructions, and replace if damaged.

If the problem remains, contact your distributor for repair or replacement

Replace the O-Rings and/or the valve seat. If the problem remains,

contact your distributor for repair or replacement

1. Get the meter off from the dispense system

2. Take off the protector

3. Loosing four the socket head cap screws on the cover of the meter

4. Loosing eight the hex bolts on the bottom of the meter

5. Take off the seat

6. Check the O-Ring, replacing the O-Ring if it is damaged

7. After replacing the O-Ring, assemble the meter and fix it back

to the dispense system

1. Get the meter off from the dispense system

2. Take off the protector

3. Take off the labels sticks on the bottom of the meter

4. Loosing the five socket head cap screws on the bottom of the meter

5. Take off the seat

6. Check the battery, replacing the battery if it is out of power

7. After replacing the battery, assemble the meter and fix it back

to the dispense system

Reset the correction factor

TEL: (08) 9209 3066

FAX: (08) 9209 3933

www.alemlube.co.nz

O30060

SA/NT

TEL: (08) 8241 7111

TEL: (09) 447 1007

FAX: (08) 8241 7011

FAX: (09) 447 1008