Alen A375 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Limpiador de aire Alen A375. Alen A375 7 páginas. Hepa
También para Alen A375: Manual del usuario (13 páginas), Manual del usuario (14 páginas)
Imprimir página
HoW To USE THE REMoTE CoNTRoL
iMPoRTANT: Your remote control requires 2 (AAA) batteries for operation.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium) batteries.
oN/off
Press this key to start
operation, press it
again to stop it.
On/Off
fAN SPEEd
Every time you press
Fan
Speed
it, the fan speed
will vary according
to the following
order:
Low
Medium
High
TIMER
Quiet
AutoRun
1 Hour
2 Hour
4 Hour
TiMER
Cancel
8 Hour
Set the operation
time. When pressing
Preset On Time
Preset Off Time
SET UP
Preset Operation Fan Speed
the key, the timer
scale on the panel
will indicate the set
Low
Medium
High
Quiet
AutoRun
time:
1 Hour
2 Hour
4 Hour
Cancel
8 Hour
Preset On Time
Preset Off Time
SET UP
Preset Operation Fan Speed
Used to set the 3
modes. On Time, Off
Time and Air Flow in
Low
Medium
High
Quiet
AutoRun
operation. When
pressed each time, it
1 Hour
2 Hour
4 Hour
will follow the order
Cancel
8 Hour
below:
Preset On Time
Preset Off Time
Preset Operation Fan Speed
8
UV
Press this key to start UV,
press it again to stop it.
UV
ioNizER
Press this key to turn on
the ionizer, press it again
IONIZER
to stop it.
+
iNCREASE
An auxillary key of the
set up key, used to
increase operation
time and fan speed.
-
Each time it is pressed,
the present time will
increase by 30 minutes
or the fan speed will
increase to the next
level.
dECREASE
An auxillary key of the
set up key, used to
increase operation
time and fan speed.
Each time it is pressed,
the present time will
decrease by 30 minutes
or the fan speed will
decrease to the next
level.
REPLACiNG THE UV LiGHT
1.
With the front of the unit facing up, pull up the lower end of the inlet grill
and push it toward the display panel at the top of the unit, then remove
it.
2.
Remove the HEPA filter by lifting the pull string.
3.
Unscrew the screws on the lampshade with a screwdriver, then remove
the lampshade.
4.
Gently rotate the bulb a quarter turn in either direction until it unlocks
from the socket. Pull the pins out of the sides of the socket, one end at a
time.
5.
Unpack the new UV bulb gently by handling the ends only. Starting with
one end of the bulb, then the other, gently insert the metal pins on the
bulb into the white slotted socket one pin at a time. Once the ends of
the buld are completely inserted into the socket, rotate the bulb a quar-
ter turn until it locks into place.
6.
Reinstall the lampshade.
7.
First install the bottom of the filter into the air cleaner, then the top.
8.
Hook the fasteners on the intake grid into the holes on the air cleaner
first, then push down on the two sides of the inlet grid until the cover
snaps into place.
www.AlenCorp.com
9