Bosch Vision 800 Series Manual de servicio - Página 18
Navegue en línea o descargue pdf Manual de servicio para Horno Bosch Vision 800 Series. Bosch Vision 800 Series 36 páginas. Gas slide-in ranges
También para Bosch Vision 800 Series: Manual de instrucciones (40 páginas), Dimensiones y especificaciones (2 páginas), Manual de instalación (6 páginas), Manual de servicio (43 páginas), Manual de instrucciones de instalación (28 páginas)
58300000194725 ARA EN B
There is a Door Lock Relay Test available in Service mode. See the
Service Mode section for details.
6.2.1 Replacing the Latch/Motor Assembly
1. Remove power to the range.
2. Remove the inner screws securing the latch to the latch plate,
then remove the outer screws securing the latch plate to the
range.
Figure 18 Front latch plate; remove/replace screws in order shown
3. Hold the latch hook and slide the latch assembly a little to the
left to disengage it from the small support bracket that sits
directly behind it, then pull the latch forward.
Figure 19 Door latch/motor assembly and rear support bracket
4. Disconnect the wires.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2016
5. Install the new latch/motor assembly, reconnecting the wires
and engaging the latch correctly with the latch support bracket.
6. Position the latch plate with the curved corners at the bottom,
and reinsert screws.
7. Restore power and test operation.
6.3
The control panel service assembly includes...
Stainless front panel with gasket along inside bottom edge
Touch panel assembly which includes keypad and taped touch
control module (TCM).
Figure 20 Control panel service assembly
The TCM is an electronic module which monitors, qualifies, and
transmits the inputs from the touch panel to the control module. After
start-up, the control module polls the TCM every 100ms to determine
which, if any, keys are activated. The response to a each key press is
controlled by the control module.
The complete control panel assembly is offered as the service
replacement for the stainless skin, touch panel, and/or TCM. These
components are not available separately.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Gas Slide-in Ranges
Control Panel
Page 18 of 36
800 944-2904