FORM FIT HDW 5R 02 Manual de inicio rápido

Navegue en línea o descargue pdf Manual de inicio rápido para Equipos de seguridad FORM FIT HDW 5R 02. FORM FIT HDW 5R 02 2 páginas. Hood protector

Imprimir página
FORM FIT
HOOD PROTECTOR
Chevrolet Avalanche with Cladding 2002-2006
Chevrolet Avalanche without Cladding 2002-2006
Thank you for purchasing a form fit hood protector.
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only.
Periodically check to make sure all the hardware is in place and the protector is secure.
Attention!
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Hardware Kit
x 5
x 5
Tools Required
Installation Instruction
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Set the protector aside. Press the expansion plugs into the holes determined in step two.
4. Re-place the protector on the hood with the expansion plugs centered in the mounting
holes.
5. Assemble the washers onto the screws (rubber side toward protector) and insert the
screws through the protector into the expansion plugs. Adjust the protector for best fit
then, tighten the screws into the expansion plugs (do not over tighten). See Illustration
#1.
Note: Do not pull on the protector when opening or closing the hood.
Illustration #1: Hardware Assembly
Made in Canada
HDW 5R 02
x 5
# 10 x 5/8'' Screws
#
2
Hood
Expansion Plug
Protector
Washer
Screw
Rev2.060804
FORM FIT
HOOD PROTECTOR
Chevrolet Avalanche with Cladding 2002-2006
Chevrolet Avalanche without Cladding 2002-2006
Thank you for purchasing a form fit hood protector.
Care Instructions
Clean the protector with a mild soap and water solution or plastic cleaner only.
Periodically check to make sure all the hardware is in place and the protector is secure.
Attention!
Do not use chemicals or solvents. Avoid using automatic car washes. Do not pull on the
protector when opening or closing the hood.
Hardware Kit
x 5
x 5
Tools Required
Installation Instruction
1. Open the hood. Be sure that the hood is clean and dry inside and out.
2. Center the protector on the hood to familiarize yourself with the mounting holes
locations.
3. Set the protector aside. Press the expansion plugs into the holes determined in step two.
4. Re-place the protector on the hood with the expansion plugs centered in the mounting
holes.
5. Assemble the washers onto the screws (rubber side toward protector) and insert the
screws through the protector into the expansion plugs. Adjust the protector for best fit
then, tighten the screws into the expansion plugs (do not over tighten). See Illustration
#1.
Note: Do not pull on the protector when opening or closing the hood.
Illustration #1: Hardware Assembly
Made in Canada
HDW 5R 02
x 5
# 10 x 5/8'' Screws
#
2
Hood
Expansion Plug
Protector
Washer
Screw
Rev2.060804