Bosch 2 Información de uso - Página 24

Imprimir página

en Troubleshooting

Fault

The set temperature is

not reached.

Fully automatic de-

frosting no longer

works.

The temperature dif-

fers greatly from the

setting.

Condensation accu-

mulates on the sur-

face of the appliance

and on the shelves in-

side.

Cause and troubleshooting

The freezer compartment door was open for a long

time. The evaporator (refrigeration unit) in the noFrost

system is heavily iced up.

Requirement: Store the frozen food well insulated in a

cool place.

Switch off the appliance. → Page 16

Disconnect the appliance from the mains.

Unplug the appliance from the mains or switch off

the circuit breaker in the fuse box.

Move the appliance away from the wall.

Leave the appliance door open.

a After approx. 20 minutes, the condensation starts to

run into the evaporation pan at the rear of the appli-

ance.

To prevent the evaporation pan from overflowing,

mop up the condensation water with a sponge.

The evaporator is defrosted if no more condensa-

tion water runs into the evaporation pan.

Clean the interior of the appliance. → Page 20

Switch the appliance back on. → Page 15

Different causes are possible.

Switch off the appliance. → Page 16

Switch the appliance back on after five minutes.

→ Page 15

If the temperature is too warm, check the temper-

‒

ature again after a couple of hours.

If the temperature is too cold, check the temper-

‒

ature again on the following day.

The water contained in warm and humid air con-

denses on the colder surfaces of the appliance.

Wipe away the water with a soft, dry cloth.

Open the appliance as briefly as possible.

Ensure that the appliance is always closed properly.