Diversity Wireless by Anchor Audio
Anchor Audio UHF wireless is a 16 channel, diversity wireless
system that utilizes two independent antennae to receive signal. The
diversity feature means that the receiver will process the stronger of
the two antenna signals, effectively minimizing dropouts and
interference from other transmitting sources. The antennae are
mounted internally so there are no obstructions or risk of damage.
Receiver Channel Selection
Before you use your UHF wireless system, you will
NOTE:
need to select a wireless frequency channel. The
If you
experience
wireless receiver is mounted inside the MegaVox Pro
ongoing
and can be set to any of 16 available channels.
interference
1. Locate the Wireless Channel selector on the
with your
back panel.
wireless
system, the
2. Using the supplied screwdriver, set the
selected
frequency of the receiver to 1 thru 16.
frequency
may be
Transmitter Channel Selection
incompatible
Handheld Transmitter:
with other RF
systems in
1. Unscrew battery cover on
your area.
lower end of microphone.
Try a different
2. Set the channel selection
channel.
dial to match the channel
setting on the receiver.
3. Replace the battery cover.
Body-pack Transmitter:
NOTE:
1. The channel selection dial
Be sure that
is located on the side of
the MIC/LINE
the transmitter.
switch is in
the "MIC"
2. Set the channel selection
position when
dial to match the channel
a mic is
setting on the receiver.
plugged into
the TX.
10
WIRELESS OPERATION
Setting Up The MegaVox Pro
For best results, it is recommended that the PA system be placed
above the heads of the audience and above the height of the tallest
obstruction using a speaker stand or table. This will benefit the
listeners in the rear while minimizing the risk of overpowering the
listeners in front.
Sound System Placement
The ideal placement of the PA system is between the crowd and the
presenter, facing the crowd. This will give the audience a direct
signal path and keep the person with the microphone behind the
sound system, helping to prevent feedback from occurring.
Stand Setup
1. Loosen the Lower Collar Knob.
2. Separate the stand legs until the
leg support cross braces are
parallel to the floor.
3. Tighten the Lower Collar Knob.
4. Extend the center pole by
loosening the Upper Collar Knob.
5. Adjust the height and retighten
the Upper Collar Knob.
6. Place the Anchor sound system
on the stand.
SYSTEM SETUP
Upper Collar
Knob
Lower Collar
Knob
Cross Braces
3
Imprimir página