Anchor UHF-6400 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Sistema de micrófono Anchor UHF-6400. Anchor UHF-6400 4 páginas. 64 channel uhf wireless system

Imprimir página

BASIC SYSTEM OPERATION

NOTE: Fully Charge Batteries Before First Use!

1. Set all Input Level Controls to minimum & Tones Controls to flat

or the middle setting before turning your system on

2. Plug a wired microphone into the MIC 1 or MIC 2 jacks and/or

plug an audio source into the LINE-IN jack

3. Switch POWER to ON, the red BATTERY LED will light

4. Slowly increase the Level Control for the input jacks used to the

desired volume

5. Set SPEECH PROJECTION to ON for speech applications or

OFF for standard applications (music & indoor use)

6. Adjust BASS & TREBLE controls to desired sound quality

NOTE: Never use the balanced & unbalanced

audio outputs the same time!

Signal loss or increased noise may occur.

CHARGING RECHARGEABLE BATTERIES

IMPORTANT: Only use for rechargeable batteries.

Attempting to recharge normal batteries will cause damage to the unit.

1. Connect the supplied DC 1.5 cable to DC OUT on the receiver

front panel.

2. Connect the other end of the cable to the charging input on

the bottom of the microphone/transmitter.

3. Charging takes approximately 10 hours to complete.

NOTE: Transmitter LED will flash during charging.

HEADPHONE MONITOR

VOLUME CONTROL

Turn knob to control

GROUP NUMBER

headphone volume level

HEADPHONE INPUT

CONNECTOR

Plug headphone into this

"M" (6.3mm) connector to

monitor receiver audio

POWER

Push to turn the

receiver on & off

UHF-6400 RECEIVER FRONT & BACK PANELS

MODEL SHOWN: WR-6400

ANTENNA B:

INPUT CONNECTOR

TNC-type connector provides

connection to supplied antennas

or coaxial cable used w/

antenna divider, antenna

boosters or remote antennas

Rotate to adjust the receiver output

LED DISPLAY:

CHANNEL NUMBER

GROUP SELECTOR

CHANNEL SELECTOR

Rotate knob to choose

Five LEDs per RF antenna channel

group number.

channel number.

glow to indicate RF signal strength

NOTE: If no LEDs are lit no signal

BALANCED OUTPUT

UNBALANCED OUTPUT

3-pin XLR connector

"M" (6.3mm) phone jack

provides balanced

provides unbalanced

low-impedance output

NOTE: Setting squelch too high will reduce the usable range of the system.

CHARGER INPUT

Connect the supplied DC 1.5mm cable

LEVEL CONTROL

to the receiver and the microphone,

and it takes around 10 hours to re-

level to match the input sensitivity

charge and the LED of transmitter is

of an audio mixer or amplifier.

flashing all the time.

RF LEVEL INDICATORS

AF LEVEL INDICATORS

Five LEDs light to indicate audio signal strength

Green = Normal Operation

RED = Approaching Overload Condition

is being received

SQUELCH

DC IN

Adjusts output level to

Input connector

suppress noise

for AC adapter

(Set to minimum before

turning receiver on)

ANTENNA A:

INPUT CONNECTOR