Formech 686 Manual de inicio rápido - Página 3

Navegue en línea o descargue pdf Manual de inicio rápido para Aspiradora Formech 686. Formech 686 6 páginas.

Changing Material Window

1. Release toggle clamps (c) and lift clamping handles so upper

window is pivoted up

2. Lift off lower window from alignment pins at the rear of the

table, replace with desired window size

3. Upper window unbolts front and back with single nut/bolt

combo, store old upper window

4. Place new upper window against new installed lower window

and lower arm over upper window and bolt into place

Loading Material/Mold

1. With desired window size installed and no material or your mold

loaded, raise the bed to its most elevated position using two

green buttons (beneath the toggle clamps) pushed simultaneously(c). The table should raise

rapidly. If the vacuum pump turns on press the vacuum button (d).

2. With table raised, fit mold in open window centered as best as possible, though the vacuum

hole at the bottom of the table needs to be covered by your mold. Make sure the metal screen

material is on the table.

3. Once satisfied with mold position lower table using the table down button (e) to just below

where material will droop but making sure the plastic will not touch once drooped.

4. With upper window raised, place plastic sheeting over foam outline. Material must cover all of

the foam table.

5. Lower upper window, clamp the toggle clamps to secure down.

Plastics Lab

Image C

V1.0 2/8/2018