AND HL-3000LWP Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Scales AND HL-3000LWP. AND HL-3000LWP 10 páginas.

Installing Batteries / Connecting The AC adapter

Installing Batteries

CAUTION

When replacing batteries, be careful

not to apply too much force to the

weighing pan. An excessive force

could damage the scale.

Remove the battery cover and insert six

batteries (R6P / LR6 / AA size) into the

battery compartment, taking extreme

care to that the polarities plus and minus

are observed. Be sure to lock the

battery cover again after installing the

batteries.

AC adapter (optional)

CAUTION

When using an AC adapter, the scale

does not comply with the IP65.

The AC input requirement could be 100,

120, 220, 230 or 240 volts (50/60Hz)

depending on the area where used, so

please verify that the adapter is correct.

Plug the AC adapter to the AC adapter

socket inside the battery compartment.

Attach the battery cover and fit the

rubber cap.

Setting up the HL-WP

CAUTION

Avoid installing the scale in direct sunlight, as that may cause discoloration

or a malfunction. Place your HL-WP on a firm weighing table so that the

scale is level. (The scale will not perform accurately when it is not level.)

Place the scale on the firm surface and adjust the feet so that the sprit level

shows the scale is level for an accurate weighing.

PREPARATION

New six batteries (R6P/ LR6/ AA size)

Close the rubber cap

Optional AC Adapter

AC Adapter jack

Battery cover lock