CommScope ARGUS Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Antena CommScope ARGUS. CommScope ARGUS 5 páginas. 296mm profile panel antennas

296mm Profile Panel Antennas

Installation Instructions

Installation Instructions – Adjustable Downtilt Mounting Kit

Assemble mounting kits as per Figure 2 and 3 of this document.

1. Attach the mounting kit assembly to the antenna, before trying to clamp the

2. Downtilt angles in 1° increments can be obtained with the correct adjustment

Upper Mounting Bracket Assembly

( To Suit Pipes OD 75-115 mm)

Figure 1: Correctly Assembled Mounting Kit Using Clamp Bracket for Mechanically

Ensure a torque spanner is used when tightening fasteners, see the mounting kit

diagrams on the following pages for the correct torque recommendations.

Ensure antenna is installed with the connectors at the bottom.

T-029-GL-E, T-041-GL-E, T-045-GL-E

brackets to the pole.

of the tilt arm bracket.

Downtilt can be achieved by aligning the corresponding hole in the tilt

arm to the pivot bracket which mates against the mounting pole, as shown in

Figure 4. The first hole is for 1° downtilt*, with each consecutive hole

resulting in an increased inclination of 1°.

( *Note for the T-045-GL-E kit the tilt is 0° then 2° - 10° in 1° steps.)

For finer downtilt angle adjustments the distance in between the top

and bottom mounting bracket on the pole can be adjusted.

For 0° downtilt the tilt arm may be stowed as show in Figure 4.

An inclinometer or other angular measuring device may be used to

verify downtilt angle as required.

Adjustable Downtilt Antenna

Bulletin D701-0013 • Revision C • November 2014 page 2 of 5

Lower Mounting Bracket Assembly

(To Suit Pipes OD 75-115 mm)