AND GXA-24A Manual de instrucciones

Navegue en línea o descargue pdf Manual de instrucciones para Equipos de grabación AND GXA-24A. AND GXA-24A 2 páginas. Usb host interface

Imprimir página

GXA-24A USB HOST INTERFACE

INSTRUCTION MANUAL

1WMPD4004885

1. Features

By using the GXA-24A USB host interface, the USB flash drive can be connected to balances.

By saving weighing data on the USB flash drive, the data can easily be acquired by a PC with Windows

or Mac OS. (Driver not required.)

The balance's weighing data is saved on the USB flash drive in CSV format.

The GXA-24A USB host interface is installed on the rear side of the balance beforehand.

In addition to directly connecting the USB flash drive to the USB Type A connector of the GXA-24A,

the USB flash drive can also be connected to the balance through the provided extension cable

(Approx. 0.5 m length).

Balance rear side

Note

Only connect the USB flash drive to the USB Type A connector.

To remove the USB flash drive from the balance, make sure that the display is turned off and the

USB connection indicator is not lit up. Operating the device improperly may result in data not

being written to the USB flash drive. (Refer to Step 6 in "4. How to Use".)

2. Applicable Models

Multi-function balances

GX-AE / GX-A / GF-A series

GX-AWP / GF-AWP series

Note

The GXA-24A cannot be used unless the balance software version is 1.500 or later.

When the GXA-24A is used with a GX-AWP/GF-AWP series scale, it will not be dustproof

or waterproof.

3. Product Composition

1) GXA-24A: USB host interface (built in the balance)

2) AX-KO3644-50: extension USB cable (0.5 m)

3) Instruction manual (this document)

GXA-24A

USB Type A connector

Cable

Software version

1.500 or later

4. How to Use

Step 1 Connect the AC adapter to the balance and turn

the power of the balance on.

Step 2 Connect the USB flash drive to the USB Type A

connector of the balance while the balance's

display is off or in weighing mode (it takes

approximately 5 seconds for the balance to

recognize the USB flash drive after the

connection).

Step 3 When the USB flash drive is recognized by the balance, the buzzer sounds and "

for approximately 2 seconds. At the same time, the USB connection indicator lights up.

(For extension)

USB flash drive starts connecting

Step 4 Change the USB data format (balance's function settings) if necessary.

* The USB data format is set to A&D standard format at shipment. By changing the USB data

format to CSV format (

This is useful for processing numerical values.

Step 5 By performing output operations using the balance, the data can be transmitted to the USB

flash drive.

Step 6 When removing the USB flash drive, perform the following.

1) Press the

Confirm that the

(Power standby indicator is lit.)

3) Remove the USB flash drive from the balance.

USB connection indicator

(Confirm that the indicator is not lit up)

Power standby indicator

(Confirm that the indicator is lit up)

Connection established

"Beep"

Approx.

5 seconds later

), the data can be divided at the numerical value section.

ON:OFF

key of the balance to turn the display off.

USB connection

indicator is not lit up.

Display off status

" is shown

Weighing mode

Approx.

2 seconds later

USB connection indicator