Carmanah F Series Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Equipos de iluminación Carmanah F Series. Carmanah F Series 18 páginas. Rrfb mast arm kit
También para Carmanah F Series: Manual de inicio rápido (20 páginas), Manual de instalación (20 páginas), Manual de instalación (16 páginas), Manual de sustitución del sistema de gestión de la energía (12 páginas), Manual de instalación (20 páginas), Manual de sustitución (9 páginas), Manual de instalación (18 páginas)

6.4

Adjusting Trigger Output Configuration

Under the "DR600 Setup", "Hardware & IO Config" tab are settings that control the system's activation behavior:

Output Hold Time: this setting controls how long the local (and any remote wirelessly-connected) Carmanah

E/F/G system(s) continue to flash after the radar module stops sensing vehicle motion. Default is 10 seconds. To

avoid erratic flashing, this setting should not be set below 5 seconds.

Trigger Event: this setting changes the conditions under which an activation of the connected Carmanah E/F/G

system is triggered:

None: no activations will occur.

•

Default: Displayed Target Above Speed Limit (default setting): Carmanah E/F/G system

•

activated when vehicle detected above configured Speed Limit on "Detection & Units" tab.

Displayed Target Below Speed Limit: Carmanah E/F/G system activated when vehicle

•

detected below configured Speed Limit on "Detection & Units" tab.

Any Displayed Target: Carmanah E/F/G system activated whenever a vehicle is detected,

•

regardless of speed.

Trigger Direction: this setting changes whether incoming vehicles, outgoing vehicles, or both will trigger the

connected Carmanah E/F/G system. Default setting is Incoming.

Click on "Save Changes" to save the changes to the radar module, or "Close" to disconnect from

the radar module without saving.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

RADAR DETECTION KIT

carmanah.com