1st-Relief VERSACHOCK Manual - Página 4

Navegue en línea o descargue pdf Manual para Cabrestantes 1st-Relief VERSACHOCK. 1st-Relief VERSACHOCK 11 páginas. Winch kit
También para 1st-Relief VERSACHOCK: Manual (10 páginas)

Imprimir página

Manual

Specifications

2.1

Tilting Davits for Soft Inflatable Boats (1st23VCTILTSIB)

Universal design fits most shapes and sizes of tender boats

2 removable tilting davit arms made of HDPE and stainless-steel hardware

4 low profile threaded deck plates and bolts included with every kit

Universal design fits most hull shapes

Capacity: 350 lbs / 158 kg

3 pcs. tie downs/D rings included (required for securing watercraft)

Twelve #10 (3/16") screws required for installation (not included)

Exclusive of any other assembly parts

2.2

Tilting Davits for Rigid Inflatable Boats (1st23VCTILTRIB)

Same features as 1st23VCTILTSIB plus:

4 adjustable bunks are included

Bunks are adjustable to fit most rigid hull shapes

Cushioning strips help protect hull

Installation

3.1

Important installation information

Please note the following important installation instructions:

We strongly recommend that the product specification, use and installation be checked by a

professional technician before purchase and that the installation is carried out by the same

person.

This manual is for advice only. THERE ARE TOO MANY HULL VARIATIONS IN ORDER

TO SPECIFY AN EXACT INSTALLATION OR AN INSTALLATION LOCATION FOR

EVERYONE.

Not intended for use in extreme conditions (i.e.: high forces from water, wind, etc.)

Tie downs must be installed in order to secure watercraft as described in chapter 3.3.

Be sure to install at least 2 stern tie downs, and one bow tie down. We also recommend

installing one tie down mid ship, which can greatly help keep the dinghy from rocking, as

well as act as a spring line.

Before each use, make sure that the davit arms are securely inserted into the deck plates.

Before each use, make sure that the chock assemblies are firmly fixed with locking screws.

Check the integrity of the hull, including hull thickness, chine and stringer locations, making

sure proper support will be provided.

Check where outboard engine will rest. A skid plate may be needed to protect deck. (Article

number 1st23VCSKEG;

Remove the davit arms when not in use.

Rinse with freshwater after each use, as saltwater and other contaminants can cause

staining, even though we use the most corrosion resistant materials.

Under no circumstances should person/s or animal be allowed in watercraft whether

loading, or in stored position.

Do not add additional gear, etc. that may subject the watercraft to be over the maximum

weight capacity.

Always pull drain plug when stored to prevent excess water to accumulate, which could

cause excess weight.

Be sure the attachment bolts are secure before each use.

Please note there are two spacing options. Standard spacing for most swim platforms and

an optional spacing for narrower swim platforms. Standard spacing holes are provided in all

models. For narrower swim platforms, the optional holes must be drilled by installer (see

diagrams in the following pages).

FAILURE TO FOLLOW THE ABOVE MAY RESULT IN DAMAGE, LOSS OR SERIOUS

INJURY!

FN:

552603b (LG f. ZRS Graz)

VAT No.:

ATU76757859

https://www.1st-relief.com/en/outboard-skeg-rest.html

page 4 of 11

Bank:

RB Graz-Mariatrost

Swift/BIC:

RZSTAT2G223

IBAN:

AT08 3837 7000 0420 9185

Handbuch VC Tilting Davits EN 1_2.docx

1st-Relief GmbH

Schulgasse 5

8010 Graz, Austria