CommScope AMP NETCONNECT 2U Multi-Fiber Push-On Hoja de instrucciones - Página 4

Navegue en línea o descargue pdf Hoja de instrucciones para Recinto CommScope AMP NETCONNECT 2U Multi-Fiber Push-On. CommScope AMP NETCONNECT 2U Multi-Fiber Push-On 4 páginas. Mpo secure rack-mounted enclosure assembly

Imprimir página
Installing MPO Adapter Plate(s)
Captive Screw
(1 Per
Front of
Adapter Plate)
Chassis
MPO Connectors of
Hydra Cable Assemblies
Connected to Ports of
MPO Adapter Plates
(Also See Figure 8)
Figure 7
3. Remove the dust cap plugs from the ports of the
MPO adapter plates to be used. DO NOT remove
the dust cap plugs from the ports not to be used.
4. Connect the MPO connectors of the hydra cable
assemblies to the applicable port of the MPO
adapter plate. See Figure 8. The port designations
and color codes are marked on the front of the MPO
adapter plate, and the MPO adapters are keyed to
match the MPO connectors of the hydra cable
assemblies.
5. REPLACEMENT AND REPAIR
DO NOT use defective or damaged product.
The enclosure is not repairable if damaged. Order
additional enclosures through your Representative, or
contact CommScope.
Technical Assistance Center (TAC)
Tel: 800.830.5056
www.commscope.com
6. REVISION SUMMARY
Initial release of instruction sheet
Rebranded to CommScope®
Rev B
MPO Connectors of
Trunk Cable Assemblies
Connected to Adapters
of MPO Adapter Plates
Front of MPO
Blank Adapter
Adapter Plate
Plate
Connecting Hydra Cable Assemblies
LC Connectors Connected to
Ports of Switch Blade
Front of
MPO Connectors of Hydra
Chassis
Cable Assemblies Connected to
Ports of MPO Adapter Plates
Figure 8
408-32067
4 of 4