Formula F-12 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Subwoofer Formula F-12. Formula F-12 8 páginas. 12? powered subwoofer
Imprimir página
6
Method B: Amplifier wiring
hookup steps for receivers
or surround sound receivers
with NO sub output jack
See Drawing 4
1. IMPORTANT: Make sure that
ALL stereo system components
including the subwoofer are turned
OFF before proceeding.
2. Following the instructions on this
page, strip and twist TWO lengths of
speaker wire that will reach between
your receiver's left and right speaker
terminals and the subwoofer amp
terminals. Make these two lengths of
wire only as long as is necessary to run
between the two components.
3. Connect one speaker wire to the
RIGHT "+" and "–" speaker terminals of
your receiver or integrated amplifier.
Then connect the other end of this
speaker wire to the RIGHT "+" and "–"
FROM RECEIVER terminals on the back
of the amp. Use the tips on determining
speaker wire polarity to make sure that
"+" is connected to "+" and "–" is
connected to "–".
4. Connect the other speaker wire to
the LEFT "+" and "–" speaker terminals
of your receiver or integrated amplifier.
Then connect the other end of this
speaker wire to the LEFT "+" and "–"
FROM RECEIVER terminals on the back
of the amp. As in step 3, double check
"+" and "–" polarity.
5. Connect your main/satellite
speakers to the amplifier OUT TO
SPEAKERS terminals.
6. You are now ready to put your
subwoofer into use.
RECEIVER OR INTEGRATED AMPLIFIER
FRONT
SPEAKERS
LEFT RIGHT
FRONT LEFT
SPEAKER
DRAWING 4 - Hookup for Receivers and
Integrated Amplifiers without a Subwoofer Output
COLOR
tighten
TOP
SHAFT
/
˝
1
STRIPPED
2
END (
/
˝)
1
2
To connect wire:
1. Unscrew (counter- clockwise)
the top (color portion)
2. Place the stripped metal wire
in the hole in the metal shaft
3. Tighten (clockwise) the top
(color portion) back down on
wire (make sure wire insulation
is not under the plastic nut).
SPEAKER WIRE
CONNECTION DETAIL
FRONT RIGHT
SPEAKER
loosen
WIRE