ATI Technologies AT4000 Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Amplificador ATI Technologies AT4000. ATI Technologies AT4000 13 páginas. 2 to 7-channel power amplifier
Imprimir página
Please Read First
CAUTION: To reduce the risk of electrical shock, do not
remove the cover (or back). No user serviceable parts in-
side. Refer servicing to qualified service personnel.
WARNING: To reduce the risk of fire or electric shock,
do not expose this appliance to rain or moisture.
The lightning flash with arrowhead, with-
in an equilateral triangle, is intended to
alert the user to the presence of uninsulat-
ed "dangerous voltage" within the
product's enclosure that may be of suffi-
cient magnitude to constitute a risk of
electrical shock to persons.
The exclamation point within an equilat-
eral triangle is intended to alert the user to
the presence of important operation
maintenance (servicing) instructions in
the literature accompanying the appli-
ance.
PRECAUTIONS:
The amplifier is a wideband design with substantial pow-
er output capability. Certain precautions must be taken to
ensure proper operation.
1. Never expose the unit to moisture
2. Never plug an input cable into the amplifier while
the amplifier is turned on.
3. Never apply the "thumb test" (touching the "hot" lead of
the input cable with your finger) to the tip of the input cable
or input jack of the amplifier. RF rectification and/or hum
will be created and could cause damage to the loudspeakers.
ATI will not be responsible for damage to the loudspeakers
due to improper use of the equipment.
4. Under no circumstances should the output terminals of the
amplifier be short-circuited.
5. Avoid restricting the airflow around the unit. Good
airflow is necessary to help insure proper operation.
6. Be sure that the loudspeakers connected can handle the
output power of the amplifier at the loudspeakers rated
impedance. The warranty on the amplifier does not cover
damage to loudspeakers that have inadequate power han-
dling capabilities.
7. Do not stack other system components or any other mate-
rials directly on top of the unit. The heat dissipating system
of the amplifier depends on free flowing air around the chas-
sis.
Safety Instructions
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
Read all the safety and operating instructions before
connecting or using this unit.
All warnings on the unit and in this operating manual should be
adhered to.
All operating and use instructions should be followed.
Do not use this unit near water: for example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet basement, or near
a swimming pool.
This unit should be installed so that its location or position
does not interfere with its proper ventilation. For example,
It should not be situated on a bed, sofa, rug, or similar surface
that may block the ventilation openings: or placed in a built-in
installation, such as bookcase or cabinet, that may impede the
flow of air through its ventilation openings.
The unit should be situated away from heat sources such as
radiators, heat registers, stoves, or other devices (including
amplifiers) that produce heat.
The unit should be connected to a power-supply outlet only of the
voltage and frequency marked on its rear panel.
The power-supply cord should be routed so that it is not likely to
be walked on or pinched, especially near the plug, convenience
receptacles, or where the cord exits from the unit.
Clean unit only as recommended in this instruction manual.
The power-supply cord of the unit should be unplugged from the
wall outlet when it is to be unused for a long period of time.
Care should be taken so that objects do not fall, and liquids are
not spilled, into the enclosure through any openings.
The unit should be serviced by qualified service personnel when:
1. The power cord or the plug has been damaged; or
2. Objects have fallen, or liquid has been spilled, into the
unit; or
3. The unit has been exposed to rain, or liquids of any kind; or
4. The unit does not appear to operate normally, or exhibits a
marked change in performance; or
5. The device has been dropped, or the enclosure damaged.
To prevent electric shock, do not use the polarized plug with an
extension cord, receptacle or other outlet unless the blades can
be fully inserted to prevent blade exposure.
Page 2