Electrolux 1 Manual de servicio - Página 7

Navegue en línea o descargue pdf Manual de servicio para Congelador Electrolux 1. Electrolux 1 32 páginas. Chest freezer
También para Electrolux 1: Manual del usuario (24 páginas), Manual del usuario (28 páginas)

Imprimir página

A.5

Installation and assembly

• The installation must be carried out by a specialised personnel.

• Follow the installation instruction supplied with the appliance.

• Do not install a damaged appliance. Any missing or faulty parts must be replaced with

original parts.

• Do not make any modifications to the parts supplied with the appliance.

• Disconnect the appliance from the power supply before carrying out any installation

procedure. Connect the appliance to the power supply only at the end of the installation.

• The appliance is not suitable for installation outdoors and/or in places exposed to

atmospheric agents (rain, direct sunlight, freeze, humid and dusty location, etc.).

• Make sure that the floor where you install the appliance is flat, stable, heat resistant and

clean.

• Access to the service area is limited to persons with the necessary knowledge of safety

and hygiene as well as practical experience of the device.

• Leave enough free space around the appliance to facilitate its use and to preform any

maintenance operations.

A.6

Water connection

• The plumbing connections must be carried out by a specialised personnel.

• The machine is to be connected to the water mains using the new supplied hose-sets.

Do not use old hose sets.

• Always use a new set of joints if you remove and re-install the water inlet pipe to the

machine.

•

Before connection to new pipes, pipes not used for a long time, where repair work has

been carried out or new devices fitted (water meters, etc.), let the water flow until it is

clean and clear.

• The operating water pressure (minimum and maximum) must be between:

– 1 bar [0.1 MPa] and 8 bar [0.8 MPa];

• Make sure that there are no visible water leaks during and after the first use of the

machine.

• Install an approved dual check valve upstream according to the regulation of the

installation country.

A.7

Electrical connection

• Work on the electrical systems must only be carried out by a specialised personnel.

• Make sure that the electrical information on the rating plate agrees with the power supply.

• Make sure to install the appliance in accordance with the safety regulations and local

laws of the country where used.

• If the power cable is damaged it must be replaced by the Customer Care Service or in

any case by specialised personnel, in order to prevent any risk.

• The appliance must be correctly earthed. The manufacturer is not responsible for the

consequences of an inadequate earthing system.

• To protect the power supply of the appliance against short circuits and/or overloads,

install a thermal fuse or a suitable automatic thermal magnetic circuit breaker, ADS

(Automatic Disconnection of Supply).

• To protect the power supply of the appliance against current leakages, install a high-

sensitivity manual reset RCD (Residual Current Device), suitable for overvoltage

category III.

For protection against indirect contacts, refer to point 6.3.3 of EN 60204-1 (IEC 60204-1)

with the use of protection devices that ensure automatic cut-off of the supply in case of