Electrolux E32AF85PQSA Manual de uso y mantenimiento - Página 14
Navegue en línea o descargue pdf Manual de uso y mantenimiento para Congelador Electrolux E32AF85PQSA. Electrolux E32AF85PQSA 23 páginas.
Imprimir páginaiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiil
2.
3.
4.
power source.
Place end of water supply line into
sink or bucket. Turn ON water supply
and flush supply line until water
is clear. Turn OFF water supply at
shutoff valve.
Remove plastic cap from water valve
inlet and discard cap.
if you use copper
tubing
- Slide
brass compression nut, then ferrule
(sleeve) onto water supply line. Push
water supply line into water valve inlet
as far as it will go (1/4" / 6.4 mm). Slide
ferrule (sleeve) into valve inlet and
finger tighten compression nut onto
valve. Tighten another half turn with
a wrench; DO NOT overtighten. See
Figure 1.
if you use stainless
steel tubing
- The nut and ferrule are already
assembled on the tubing. Slide
compression nut onto valve inlet and
finger tighten compression nut onto
valve. Tighten another half turn with
freezer as shown and arrange coils
so they do not vibrate or wear
against any other surface.
Turn ON water supply at shutoff valve
and tighten any connections that leak.
Reconnect freezer to electrical
power source.
To turn ice maker on, lower wire
signal arm (side mounted) or set the
ice maker's On/Off power switch to
the "l" position (rear mounted).
_lastic Water Tubing
Ice Maker
Clamp
Compression
Nut
_le
(Sleeve)
water
line
Water Valve
Bracket
inlet
Water Valve
Copper
water
line
from household
water
supply
include enough
tubing
in loop to
al ow moving
refrigerator
out
for cleaning)
Figure 1
Plastic Water Tubing
to Ice Maker
Fill Tube
Steel
Clamp
_--- Stainless
Steel
water Line
-Water Valve
/_
Bracket
///_
_ Valve inlet
- Water Valve
///6
ft. Stainless Steel water line
f
from household water supply
ii!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!!i;!_ii