Bosch Instructions for Use Manual de instrucciones de instalación - Página 11

Installation

Attaching and aligning the appliance.

Mark the hole for the safety screw.

Remove the appliance once more.

Drill an 8 mm Ø hole to a depth of 80 mm for the safety

screw and press the wall plug flush into the wall.

Initially remove the protective foil from the back of the

appliance and, following installation, remove the foil

completely.

Attach the appliance.

Screw in the safety screw - and washer - and tighten all the

screws.

Connecting the air extractor

Note: If using an aluminium pipe, smooth the connection area

beforehand.

Attach the air extractor pipe directly to the air-pipe connector.

Connect to air extractor opening.

Seal the joints appropriately.

Connect the power supply

Plug the mains plug into the earthed socket.

If a fixed connection is required, please follow the instructions

in the Electrical Connection section.

Risk of injury!

Components inside the appliance may have sharp edges. Wear

protective gloves.

Separate the flue ducts.

To do this, remove the adhesive tape

Remove the protective foil from both flue ducts.

Screw the upper flue ducts to the sides of the fixing bracket

using two short screws.

Place the lower flue ducts on the appliance and fix in place

using two long screws on the bottom of the appliance.

Screw the lower flue duct to the sides of the fixing bracket

using 2 short screws.

Note: Align the flue duct before tightening the 2 screws.

[