Community R.35-3896 Manual de instalación y funcionamiento - Página 7
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Altavoces Community R.35-3896. Community R.35-3896 17 páginas. R series
También para Community R.35-3896: Manual de instalación y funcionamiento (13 páginas)
Imprimir página
MOUNT THE LOUDSPEAKER
The factory yoke uses threaded studs and a nut / lock
washer / flat washer combination rather than bolts. This
makes it easier to attach the loudspeaker to the yoke after
the yoke is mounted to the support structure.
q Attach the loudspeaker to the yoke. See Figure 3. Screw
an 8mm stud into each side of the loudspeaker so that it
protrudes about 3/4" (19mm). Place the rubber washers on
the studs and then lift the loudspeaker into place between
the yoke arms. Attach as shown. Support the enclosure until
both sides are secured. Tighten bolts to finger tight (enough
to hold the loudspeaker in position).
q Determine the approximate angle of downward tilt. It
must be angled at least 5° down from horizontal to maintain
the stated enclosure IP55 rating. Tighten the hex nuts until
sufficiently tight enough to hold the angle.
IMPORTANT: The loudspeaker is not designed to be
rotated 90° or mounted upside-down. Doing so may cause
water pooling in the safety cable recess, compromising
rigging safety and performance, and may void the product
warranty. Pan-tilt and full rotation yokes are available for
multi-angled and down-fire applications.
ATTACH SAFETY CABLE
q Attach a safety cable to the integrated eyebolt on the
rear of each loudspeaker (see Figure 4). The safety cable
and hardware are not included. Please consult a structural
engineer for the appropriate cable for the load and
application. The safety cable must be secured to a suitable
load-bearing point separate from the loudspeaker mounting
point, with as little slack as possible, so as not to develop
undue kinetic force if the R-Series mounting were to fail.
R.15COAX, R.35COAX, R.35-3896
Installation and Operation Manual
2" OD
Rubber Gasket
8 x 32 mm SS Stud
(leave 3/4" sticking out)
Enclosure
Enclosure
R.35
Figure 3. Mount the loudspeaker to the yoke
R.15
Attach safety cable here
Figure 4. Attach the safety cable
Yoke
R.15
8mm SS Lock Washer
8mm SS Hex Nut
8mm SS Flat Washer
2" OD
Yoke
Rubber Gasket
8mm SS
Hex Nut
8mm SS
Lock Washer
8mm SS Flat Washer
8 x 32 mm SS Stud
(leave 3/4" sticking out)
R.35
Page 7