Community R.35-3896-EN Manual de instalación y funcionamiento - Página 9
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Altavoces Community R.35-3896-EN. Community R.35-3896-EN 13 páginas. R series
Imprimir página
ACCESSORIES
R-VTY35 VARY-TILT YOKE FOR R.35
R-FRY35 FULL ROTATION YOKE FOR R.35
EC STATEMENT OF CONFORMITY
This document confirms that the range of products of Community Professional Loudspeakers bearing the CE label meet all
the requirements laid down by the Member States Council for adjustment of legal requirements, furthermore the products
comply with the rules and regulations referring to the electromagnetic compatibility of devices from 16 April 2016.
The Community Professional Loudspeaker products bearing the CE label comply with the following directives: Low Voltage
Directive 2014/35/EU and the Waste from Electrical Equipment Directive 2002/96/EC RoHS.
The authorized declaration and compatibility certification resides with the manufacturer and can be viewed upon request.
The responsible manufacturer is the company:
Community Light & Sound
333 East Fifth Street, Chester, PA 19013 USA
Phone: 1+610-876-3400 • www.communitypro.com
R.35-3896-EN
Provides pan-tilt operation.
Zinc-rich epoxy dual-layer
powder-coated steel with
hardware, color-matched to
loudspeaker.
Provides full rotation mounting
capability
for
down-firing
application (i.e. top of press
box). Zinc-rich epoxy dual-layer
powder-coated
steel
hardware, color-matched to
loudspeaker.
Installation and Operation Manual
MAINTAINING WEATHER RESISTANCE
GUIDELINES FOR OUTDOOR USE
The R.35-3896-EN is suitable for outdoor installation when used
as recommended.
• Always orient the loudspeaker so the mouth of the horn
is, at a minimum, pointing at least 5 degrees downward.
Failure to do this could result in water collecting inside the
enclosure under extreme weather conditions.
• Be careful not to scratch or scrape the finish on the grille,
yoke, or enclosure.
• All mounting holes must be sealed off with the stainless
steel bolts, washers, and rubber washers supplied. If, for
any reason, these bolts must be removed, seal off the hole
with silicone caulking or some other suitable weather-tight
sealant.
• The rubber washers supplied with the mounting bolts must
always seat against the enclosure.
• The grille assembly is designed to prevent normal and
wind-driven rain from directly entering the mouth of the
loudspeaker. The grille is not designed to withstand such
with
things as being directly sprayed from a hose; therefore this
should be avoided.
• If you use any hardware in place of hardware provided
with your R SERIES loudspeaker, it should also be made of
stainless steel.
Page 9