Bosch Programme Table Manual de instrucciones de instalación y funcionamiento - Página 21

Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Secadora Bosch Programme Table. Bosch Programme Table 32 páginas. Front-loading washing machine
También para Bosch Programme Table: Manual de instrucciones (10 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones de instalación y funcionamiento (32 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones de instalación y uso (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones de uso, mantenimiento e instalación (24 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones de uso, mantenimiento e instalación (24 páginas), Instrucciones de uso e instalación (29 páginas), Manual de instrucciones (8 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (8 páginas)

Bosch Programme Table Manual de instrucciones de instalación y funcionamiento
Programme terminated
unexpectedly.
Spinning during drying
Drying result not
satisfactory.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment i
The laundry is not dried.
No messages on the display
panel.
The door cannot be
opened.
Emergency unlock.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and unplug the mains plug from the socket.
– Turn off the tap and call the after-sales service → page 22.
The A (Start/Pause) button has been
pressed accidentally.
No fault
The laundry clings to the sides of the
drum after being spun.
Closed tap
Maximum load exceeded.
Drying time selected too short.
Maximum or minimum load not taken
into account → page 28
The fabric softener compartment insert
is not correctly attached or is blocked.
The tap is turned off.
The laundry load is too large.
The drying time is too short.
Power failure.
$ (Rinse stop) is selected.
The programme is running or the door
is locked for safety reasons.
Power failure.
In order to unlock the door mechanically in the event of a power failure, you will
have to:
turn the programme selector to Off and unplug the mains plug from the
socket.
open the base panel and drain out the water → page 18.
pull the emergency release downwards and open the door at the same time.
– Before opening the door, make sure that there is no water or hot
detergent solution in the washer dryer.
Under no circumstances open the door with the emergency release while the
drum is still turning.
Press the button again to restart the
programme.
"Thermo spin", which is for energy-effi-
cient drying, starts after a drying time
of approx. 10 minutes.
Loosen up the laundry by hand; start
the drying programme → page 15.
Turn on the tap.
Reduce the load for the programme
accordingly → page 28.
Select the drying time according to the
load and the type of fabric.
Once the programme has ended:
adjust the load quantity, select a
suitable drying programme and restart.
Clean the fabric softener compartment
insert and fit it correctly in the
compartment i → page 17.
Turn on the tap.
Reduce the amount of laundry.
Select a suitable drying time.
The programme continues when power
is restored. If you wish to remove the
laundry during a power cut, you must
first drain out the water → page 18.
Check whether:
– the plug is plugged into the socket
correctly.
– the circuit breaker (fuse) has
tripped; if it has, call the after-sales
service → page 22.
Select the programme
Spin and press A (Start/Pause).
Wait until
appears on the
display panel.
Unlock the door mechanically.
[+ B
Drain +
21