Bosch Programme Table Manual de instrucciones - Página 7

Imprimir página

Bosch Programme Table Manual de instrucciones

Installation

– Scope of delivery: dryer, installation and operating instructions.

– Check dryer for transport damage.

– The dryer is very heavy. Do not attempt to lift it on your own.

– Be careful to avoid sharp edges.

– Do not set up in a room that is susceptible to frost. Freezing water may cause damage.

– If in doubt, have the appliance connected by a specialist.

– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.

Setting up the dryer

– The appliance plug must always be accessible.

– Ensure that the appliance is installed on a clean, level

and firm surface.

– Do not obstruct the air inlet on the front of the dryer.

– Keep the area around the dryer clean.

– Make the dryer level using the threaded feet

and a spirit level.

– Do not remove the threaded feet under any

circumstances.

Do not set up the dryer behind a door or sliding door, as this may obstruct

the dryer door or prevent it from opening. This will prevent a potentially

fatal danger to children from locking themselves in.

Mains connection

see Safety instructions

– Connect to an AC earthed socket. If in doubt have the

socket checked by a specialist.

– The mains voltage and the voltage shown on the rating

plate (

page 10) must be the same.

– The connected load and necessary fuse protection are

specified on the rating plate.

Frost protection / Transport

Frost protection - preparation

1. Empty the condensation container

2. Select any programme using the programme selector.

3. Press the

Start/Stop button

the container

4. Wait 5 minutes and then empty the condensation container again.

5. Turn the programme selector to Off.

Transport

– Prepare the dryer

see Frost protection - preparation.

– Transport the dryer in a vertical upright position.

– Following transportation, do not use the dryer for two hours.

The dryer contains residual water;

this can flow out if the dryer is tilted.

Signal

Switching on/off an acoustic signal at the end of the programme

Turn to

Press and hold Low heat

1 x to the

Off

and turn 3 x to the right

right

Low Heat

light on

an acoustic signal at the end of the programme is switched on.

Low Heat

light off

an acoustic signal at the end of the programme is switched off.

Take all accessory parts out of the

drum. The drum must be empty.

page 13.

Clean and level

Make sure that the air inlet

remains unobstructed

Do not operate the dryer if

there is a danger of frost.

page 4.

condensed water is pumped into

Press Low heat

switch on/off the signal

Care and cleaning

Heat exchanger

The dryer's heat exchanger is cleaned automatically during drying.

Do not pull out the condensation container during the cleaning process.

Dryer housing, control panel, air intake

Wipe with a soft, damp cloth.

Do not use harsh cleaning agents or solvents.

Remove detergent and cleaning agent residue immediately.

Filter in the condensation container

The filter is cleaned automatically when the condensation container is emptied.

However, the filter should still be cleaned regularly under running water

stubborn deposits/dirt from building up.

1. Pull out the condensation container.

2. Pull the filter out of its snap-in lock.

3. Clean the filter under running water or in the dishwasher.

4. Refit the filter.

5. Insert the condensation container so that it locks into place.

Only operate the dryer with the filter inserted.

Moisture sensor

The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how

damp the laundry is. A thin layer of limescale may build up on the moisture sensors after

prolonged use.

1. Open the door.

2. Clean the moisture sensors using a damp sponge with a rough surface.

Do not use steel wool or abrasive materials.

Turn to

Off

Appliance must be switched off.

This prevents