Bosch WT34A202IN Manual de instrucciones de instalación y funcionamiento - Página 33
Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Secadora Bosch WT34A202IN. Bosch WT34A202IN 40 páginas.
![Bosch WT34A202IN Manual de instrucciones de instalación y funcionamiento](/uploads/products/server2/1421821/1421821.jpg)
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
¥ on the display panel.
Dryer does not start.
Display panel goes off and
Start button flashes.
Programme terminates
shortly after starting.
The door opens by itself.
Creasing.
Water is leaking out.
Laundry is not dried cor-
rectly or is still too damp.
* depending on the model
Cause/remedy
Clean the fluff filter. Select the Start button to reset the displayed indication and
■
then select the Start button again to restart the appliance if necessary.
Check if exhaust air duct is blocked or bent. Clean the exhaust air duct
■
Page 32. If necessary, clean the insect screen on the exhaust air pipe.
~
Mains plug plugged in or fuse checked?
■
Start button selected?
■
Dryer door open? Close the door.
■
Program selected? Select a program.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Program starts after a delay.
■
Not a fault. Energy saving mode is active
Ambient temperature greater than 5 °C?
■
Is the appliance loaded with the laundry?
■
Load too small for selected programme? Use timed programme.
■
Loaded laundry dry?
■
Push the door closed until you hear it engage.
Creasing occurs when you have exceeded the maximum load or selected the
■
wrong program for the type of fabric. All the required information can be found
in the program table.
Remove clothes immediately after drying. Creasing may occur if they are left in
■
the drum.
Not a fault. The dryer may be positioned on an incline. Level the dryer.
After the end of the program, warm laundry feels damper than it actually is.
■
Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry will become drier
Select a program with a longer drying time or increase the drying level. This
■
does not increase the temperature.
Select a timed program for subsequent drying of laundry that is still damp
■
~
Page 25.
If you have exceeded the maximum load for the program, the laundry may not
■
be dried properly.
Clean the moisture sensor in the drum. A fine layer of limescale or particles
■
from the detergent and care products used in washing may residue on the sen-
sor and adversely affect it performance. It may cause that your laundry will not
dry properly
~
Page 32.
Drying has been interrupted as a result of a power cut, because the condensate
■
container is full or because the maximum drying time has been exceeded.
Note: .
See also the laundry tips
Faults and what to do about them
Page 12.
~
Page 24.
~
en
~
Page 27.
33