Bosch WTA34 Series Instrucciones de reparación - Página 14

Navegue en línea o descargue pdf Instrucciones de reparación para Secadora Bosch WTA34 Series. Bosch WTA34 Series 15 páginas. Vented tumble dryer

TUMBLE DRYER

New control and power module

Appliances from FD 7704 will receive a new control and power module mask 4 (software

version V 4.00 is indicated on the processor).

Instead of "clocking" – "scan" conductivity measurement – identification of empty drum

or dry washing identified (4 minutes).

Scan at changed reserve times 40 sec. on right / 20 seconds on left.

Time remaining display in time programme in minutes (appliances with *

Changed fluffing recognition system (filter / cooler). NTC R4 is not applicable.

Changed temperature ranges of the NTCs. NTC R3 –15 C / 105 C.

NTC R2 –15 C / 200 C.

Switchover model from 16 A to 10 A via test program.

Activate test program.

Set programme selector to rotary-iron dry.

Press Start button.

Buzzer on the operating module

The buzzer on the operating module is available as a spare part (Mat. no.: 16 8577) from the

logistics centre in Fürth. When replacing the buzzer, note the polarity on the instruction

leaflet.

Increase to customer-service index /04

Control and power module mask 5 (software version V 5.00 is indicated on the processor),

process fan drum and heater new. The modified software reduces the process temperature

(NTC R2 heater, NTC R3 exhaust air). Fan drum (process air) has been changed from

145 mm to 155 mm. To obtain a more satisfactory measurement of the air flow, the position

of the NTC and thermal cut-out on the heater has been changed.

Etwas fehlt hier

r120085e -15/14

04.99

16 A model

Display model

10 A model

Switch over

Press "Low

model

heat" button

Press Start

button

Display 16

"Low heat" LED on

Display 10

"Low heat" LED off

Display and "Low

heat" LED flash

The last displayed

status is

acknowledged