Bosch WTA74200GB Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Secadora Bosch WTA74200GB. Bosch WTA74200GB 10 páginas.
Imprimir página
Care and cleaning
Only when the appliance is
Installation
switched off.
Dryer housing and control panel
– Scope of delivery: dryer, operating and installation instructions, basket for woollens
– Wipe clean with a soft, damp cloth.
(depending on the model).
– Do not clean with a water jet.
– Check the dryer for transport damage.
– Remove detergent and cleaning agent residue immediately.
– The dryer is very heavy. Do not attempt to lift it on your own.
Exhaust air duct
Exhaust air duct installation instruction
.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Check the exhaust air duct as it may be clogged.
Clean the exhaust air duct at regular intervals, e.g. every six months.
– Do not set up in a room that is susceptible to frost.
Do not bend the exhaust air duct.
Freezing water may cause damage.
– If in doubt, have the appliance connected by a specialist.
1. Switch off the dryer and allow it to cool down.
2. Disconnect the mains plug.
Setting up the dryer
1.
– The mains plug must always be accessible.
3. Remove the exhaust air duct.
– Ensure that the appliance is placed on a clean, level
4. Clean the exhaust air duct.
and firm surface.
5. Refit the exhaust air duct.
– Install the exhaust air duct
Moisture sensors
installation instruction.
– Keep the area around the dryer clean.
The dryer is equipped with stainless steel moisture sensors.
– Level the dryer using the threaded feet
Moisture sensors measure the moisture level of the laundry.
and a spirit level.
After sustained, repeated operation, a fine layer of limescale
Never remove the threaded feet!
may form on the moisture sensors.
Do not install the dryer behind a door
1. Open the door.
or sliding door which could prevent or
2. Clean the moisture sensors with a damp sponge which has a rough
obstruct the dryer door from opening.
surface.
This will prevent children from locking
themselves in and risking their lives.
Do not use steel wool or abrasive agents!
2.
For mains connection,
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (
same.
– The connected load and necessary fuse protection are specified on the rating plate.
8
Optional accessories
(order from the after-sales service using the order number, according to model)
Exhaust air duct set
WTZ
The exhaust air is extracted via a hose.
1130
Washer-dryer stack connection set
WTZ
11410
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. This connection set must always be used to secure the dryer to the washing
machine. With pull-out worktop: WTZ 11400.
Platform
WMZ
20500
For easier loading and unloading. The basket contained in the drawer can be used
to carry the laundry.
Take all accessory parts out
of the drum.
Technical data
The drum must be empty.
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
Exhaust air duct
Weight
approx. 36 kg
Max. capacity
7 kg
Connection voltage
220-240 V
Connected load
2200 W
Fuse protection
10 A
Ambient temperature
5 - 35°C
Product number
Inside of door
Production number
The rating plate can be found on the back of the dryer.
Consumption rates
Clean and level.
Residual moisture in the fabrics
Fabrics/programmes
Drying time**
see Safety instructions
page 13.
after spinning
Cottons 7 kg
page 10) must be the
Cupboard Dry*
1400 rpm
(50%)
1000 rpm
(60%)
800 rpm
(70%)
Easy Iron*
1400 rpm
(50%)
1000 rpm
(60%)
800 rpm
(70%)
Easy-Care 3.5 kg
Cupboard Dry*
800 rpm
(40%)
600 rpm
(50%)
* Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Fabrics/programmes
Drying time
Cottons 7 kg / 3.5 kg*
Cupboard Dry***
97 min / cycle
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
9
After-sales service
If you cannot rectify the fault yourself (e.g. switching off/on)
What to do if..., page 11/12,
please contact our after-sales service. We will always find an appropriate solution and avoid
unnecessary visits by engineers.
The contact details of your local after-sales service can be found in the enclosed after-sales
service directory.
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
Please provide the after-sales service the product number (E no.) and the production number
(FD) of the appliance.
You can find this information:
inside the door* / in the opened service flap*
and on the rear of the appliance.
*depending on the model
Product number
Production number
Trust the expertise of the manufacturer. Contact us for assistance. In this way, you can rest
assured that the repair will be carried out by trained service technicians using original spare
parts.
What to do if ...
Turn the programme selector to Off and remove the mains plug from the socket.
The Start/Pause indicator light
Mains plug plugged in?
Energy
does not light up.
Programme selected?
consumption**
Check the socket fuse.
The display panel light and
Energy-saving mode is activated
see the separate
indicator lights (depending on
Energy-saving mode instructions.
107 min
3.16 kWh
model) go out and the Start/
128 min
3.95 kWh
Pause indicator light flashes.
149 min
4.60 kWh
The display panel switches off.
The appliance goes into the sleep mode after activating
Finished in option
page 5.
83 min
1.96 kWh
(Fluff filter/Exhaust air duct)
Clean the fluff filter
page 4.
99 min
2.92 kWh
indicator light flashes.
Press the Start/Pause button to reset the displayed
116 min
3.63 kWh
indication and then press the Start/Pause button again
to restart the appliance if necessary.
Exhaust air duct blocked or bent?
47 min
1.32 kWh
Clean the exhaust air duct
page 8.
If necessary, clean the insect screen on the exhaust air
59 min
1.72 kWh
pipe.
Dryer does not start.
Start/Pause button selected? Door closed?
Programme set?
Programme terminates shortly
Ambient temperature greater than 5°C?
Annual energy consumption
after starting.
Is the appliance loaded with the laundry?
Load too small for selected programme?/Use timed
programme
page 6/7.
Loaded laundry dry?
482 kWh / year
Water is leaking out.
Make sure the dryer is level.
The door opens by itself.
Push the door closed until you hear it engage.
11
10
What to do if ...
Safety instructions
Drying result is not satisfactory
Warm laundry feels damper than it really is.
Emergency
– Pull the mains plug out of the socket immediately or disconnect the fuse.
(laundry feels too damp).
The selected programme does not suit the load. Use
ONLY use the
– in rooms inside the house.
another drying programme or, in addition, select the
dryer...
– for drying fabrics.
timed programme
page 7.
The dryer must
– be used for purposes other than those described above.
Dryer installed too closely to other objects? Provide
NEVER...
– be modified in terms of its technology or attributes.
adequate air circulation.
Dangers
– The dryer must not be used by children or persons who have not been
Use
Fine adjust for the dryness levels
page 5.
instructed in its use.
– Do not leave children unsupervised near the dryer.
Fine layer of limescale on the humidity sensors
Clean the moisture sensors
page 8.
– Keep pets away from the dryer.
– Remove all objects from the pockets of garments.
Programme termination, e.g. mains power supply failure,
Pay particular attention to cigarette lighters
door open or maximum drying time reached?
– Do not lean or sit on the door
Drying time too long.
Clean the fluff filter under running water
page 4.
– Open the door with care. Hot steam may escape.
Insufficient supply of air
Ensure that air can circulate.
Installation
– Fasten down loose leads
– Do not operate the dryer where there is a risk of frost.
Ambient temperature greater than 35°C
Ventilate the
– The safety information in the separate installation instructions for the exhaust
room.
air duct must be observed without fail.
The humidity in the room
Make sure the room is sufficiently ventilated.
Mains
– Connect the dryer to an AC earthed socket according to specifications, as
increases.
Exhaust air duct installed/the exhaust air routes directly
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
into the open air?
Installation instructions for exhaust
– The cable cross-section must be sufficient.
air duct, page 1.
– Only use earth-leakage circuit breakers with the following symbol:
One or more indicator lights are
Clean the fluff filter
page 4/11.
– The mains plug and socket must be compatible.
flashing.
Check the installation conditions
page 9.
Exhaust air duct blocked or bent?
– Do not use multiple plugs/couplings and/or extension cables.
Clean the exhaust air duct
page 8.
– Do not touch or hold the mains plug with wet hands
Switch off, allow to cool, switch back on, and restart the
shock.
programme.
– Never pull the mains plug out of the socket by its cable.
Power failure.
Remove the laundry from the dryer immediately and
– Do not damage the mains lead
spread out. This allows the heat to dissipate. Be careful
Operation
– Only load the drum with items of laundry.
as the door, the drum and the laundry may be hot.
Check what has been loaded before switching the dryer on.
Condensation in the exhaust air
Exhaust air duct too long? Check the maximum exhaust
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
duct.
air duct length. Further information
grease or paint (e.g. hair spray, nail polish remover, stain remover, cleaning
Installation instructions for exhaust air duct.
solvent, etc.)
– Dust risk (e.g. coal dust or flour): do not use the dryer
Risk of explosion.
– Do not put laundry containing foamed material/rubber in the dryer
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
– Switch off the dryer once the programme has ended.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer with a faulty mains cable. In order to avoid danger, have
the mains lead replaced only by our after-sales service.
Spare parts
– For safety reasons, you must only use genuine spare parts and accessories.
Disposal
– Dryer: Disconnect the mains plug, then cut the mains cable off the appliance.
Dispose of the appliance at a municipal waste disposal site.
– Packaging: Do not allow children access to items of packaging
Risk of suffocation.
– All materials are environmentally friendly and reusable. Dispose of them
in an environmentally responsible manner.
Emergency
– Pull the mains plug out of the socket immediately or disconnect the fuse.
12
Risk of explosion
Risk of tipping.
Risk of tripping
Risk of electric
Risk of electric shock.
Risk of fire/explosion.
Dryer
elastic
en Instruction manual
13