ANDERSON-NEGELE NSL-F-02 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Accesorios ANDERSON-NEGELE NSL-F-02. ANDERSON-NEGELE NSL-F-02 20 páginas. Continuous level sensor. sensors for food and biopharma.
También para ANDERSON-NEGELE NSL-F-02: Manual de instrucciones (20 páginas)

Imprimir página

NSL-F Series Operating Manual

(1) Briefly press the right button.

(2) Press and hold the right button, and then select the desired mode (e.g. Setup) or node (e.g. Signal int), leaf

through the menu with the right/left button and confirm the selection by pressing and holding the right but-

ton.

(3) Press and hold the left button, and enter the ID number from right to left. Proceed as follows:

a.) Select the desired position (navigation with the right/left buttons, press the left button, change the

position to the left, press the right button, change the position to the right).

b.) At the desired position, press and hold the right button until the field becomes gray. Then enter the nu-

merical value with the right/left buttons and confirm by pressing and holding the right button until the gray

area disappears. Then enter the next digit.

c.) When all digits have been entered, move all the way to the left with the left button until the field be-

come gray.

Then press and hold the right button. The system jumps to the selected parameter and it can be entered

or changed in the same manner. Start by pressing and holding the right button.

For some system-related parameters, you are asked to confirm that you really wish to make the change. Do

this by pressing the left and right buttons.



Display:

Measured value output at

the current output

Parameter/parameter

name

2 individual configurable LEDs on the display unit:

LED1 = left LED

Dry running: LED flashes every second if sensor says „no media". In normal state this LED

is turned off.

LED2 = right LED

Power ON Signal – device error: The right LED glows constantly in normal state as long as

the sensor is supplied with power. If device error occurs, this LED flashes very fast (pulse

approx. 0,4 sec.)

Press the right button to change the parameter or save the change.

Press the left button to leave the setting without changing it.

Value currently set for this parameter

Node/module

Value name