CAROL DW-26 Manual de instrucciones - Página 10
Navegue en línea o descargue pdf Manual de instrucciones para Sistema de micrófono CAROL DW-26. CAROL DW-26 10 páginas. 2.4g digital wireless microphone system
Imprimir páginaOperating Procedure
DW-26接收機
DW-26 Receiver
Hold down the Power
按壓電源
About 2 seconds
約兩秒
Start up device
完成開機
Connection failed
Pairing successful or not
連接是否成功
Connection
連線成功
Sound transmission
聲音傳輸
Hold down the Power
按壓電源鍵
About 3 seconds
約三秒
Turn off device
完成關機
6.Frequently Asked Questions and Troubleshooting
1. Wireless receiver does not turn on: check whether the connected power
bank has enough power, or whether the power supply is working nor-
mally.
2. Status LED on the transmitter does not light up when power is on: check
if the batteries are properly installed or have enough energy.
3. Status LED on the transmitter keeps blinking: check if the batteries have
enough energy, or if the Receiver turns on.
4. No sound: Please check if the volume is set too low, or if the sound cable
is properly connected.
5. The maximum effective distance between the Digital Wireless Transmitter
and the digital wireless receiver is 20m indoors and 30m in open outdoor
areas. Exceeding this range may lead to get disconnected.
14
DW-26發射機
DW-26 Transmitter
Hold down the Power
按壓電源
About 2 seconds
約兩秒
Start up device
完成開機
連線失敗
Pairing successful or not
連接是否成功
Restart pairing
重新連線
Connection
連線成功
Audio signal
音訊傳送
Sound transmission
聲音傳輸
Hold down the Power
按壓電源鍵
About 3 seconds
約三秒
Turn off device
完成關機
7.Certification
1.CE
EMC：EN 301489-1 / EN 301489-3
RF：EN 300440
LVD：EN 60065
2.FCC
(Tx+Rx)：FCC Part15C(Certification)
3.NCC
(Tx+Rx)：LP0002
4.FCC Compliance Statement
1.1 Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
1.2 In order to comply with the regulations of FCC Radiated Emission Limits, do not
place or operate this transmitter and its antenna together with another an-
tenna or transmitter.
1.3 This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference ； (2)
This device must accept any interference received, including interference that
may cause undesired operation.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements,
the antenna(s) used for DW-26 Receiver must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. No change to the antenna or the
device is permitted. Any change to the antenna or the device could result in the device
exceeding the RF exposure requirements and void user's authority to operate the device.
FCC INFORMATION
The equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause
harmful interference to radio communication. However, there is no grantee that
interference will not occur in a particular installation. If this equipment dose cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on , the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
15