Airtec Expert CYPRES 2 Manual rápido - Página 14
Navegue en línea o descargue pdf Manual rápido para Instrumentos de medida Airtec Expert CYPRES 2. Airtec Expert CYPRES 2 16 páginas.
Important Notes
To make sure that a Military CYPRES device is armed when it is used
●
in Training Mode, you must fly at least 1500ft above the preset firing
altitude. The Military CYPRES device is always armed when in
Operational Mode.
A two canopy scenario can occur, if the main deploys too low and the
●
opening reaches into the activation window.
In case of Training mode only: After take-off
●
than 180 feet per minute (1 meter / second) for at least 30 seconds.
The drawing below shows what must be adhered to
when using the Military CYPRES in Training Mode!
If the Military CYPRES is used in Operation Mode,
the above mentioned limitations do not apply.
The CYPRES 2 is waterproof (in fresh and salt water) for - 15 ft for up
●
to 15 minutes; - 8 ft for up to 24 hours
After contact with water, CYPRES must be switched OFF after exiting
●
the water. - replace filter before next use
After an activation, the cutter can be replaced by any rigger / packer.
●
After the change, perform a self test and the unit can be used again
immediately.
After 14 hours have passed, every CYPRES unit will switch off
●
automatically. No matter of the actual location.
Airtec GmbH & Co. KG Safety Systems
For Users !
NO !
issue 2017-10
please ascend at more
min.
1500 ft
activation
altitude
Art.No.:14133030
14