ANDI WMA 7612 L Desmontaje - Página 13

Navegue en línea o descargue pdf Desmontaje para Lavadora ANDI WMA 7612 L. ANDI WMA 7612 L 14 páginas.

36- DOOR LOCK WIRE AND OPENING MECHANISM

• Remove top plate and front panel.

• Remove the clamp securing the door switch cable outer sleeve.

• Pull downwards to release the outer sleeve of the wire.

• Release wire and unhook inner wire from door switch.

• Release the plastic snaps on the switch and pull free.

37- HEATER

• Remove the rear panel.

• Heater cables are disconnected. ( figure 15)

• Loosen the heater M6 bolt and the heater is released from the tub (

When re-mounting, the heater should be secured by the heater fixture

clip in the tub ).

38- THERMOSTAT BULP AND ITS SEALING

• Remove the rear panel.

• Pull out the thermostat bulp/NTC from the tub.

• Pull out the thermostat rubber sealing from the tub ( when remounting

the thermostat rubber sealing, ensure a water tight seal in the tub).

39- INTERFERENCE SUPPRESSOR

• Remove top lid.

• Disconnect interference suppressor cables.

• Remove the two screws in the plastic box behind the machine that

secure the terminal group to the cabinet.

• Disconnect the interference supplier by loosening M8 nut.

40- UPPER COUNTER WEIGHT

• Remove the top lid.

• Remove the upper counter weight fixture screws and pull off the counter

weight.

Figure 15