Bosch WTY87879SN Manual de instrucciones de instalación y funcionamiento - Página 37
Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Secadora Bosch WTY87879SN. Bosch WTY87879SN 44 páginas.
Imprimir página
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
Please empty
the condensate con-
tainer on the display
panel and the drying
cycle is interrupted.
Please clean the fluff
filters on the display
panel.
Heat exchanger is
being rinsed on
the display panel.
Dryer does not start.
Creasing.
Water is leaking out.
Change in the pro-
gramme duration dis-
played during drying.
* Depending on the model
Cause/remedy
Empty the condensate container; and the dryer; .
■
If the optional condensation drain* is installed, the drain hose may be
■
blocked or kinked. Check the hose for deposits and rinse the hose. Lay
the hose without any kinks.
Clean the fluff filter and press the Start button ~ Page 32.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out
the condensate container while this is displayed.
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay ~ Page 29.
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table ~ Page 27.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
Faults and what to do about them
en
37